JVC TH-A10 - Manual (Page 18)

16
The basic operations for this system are as follows.
IMPORTANT
Check that remote control mode selector is set to the current
position when using the primary remote control:
Set to “AUDIO/TV/VCR” to operate an audio system, TV, or VCR.
Set to “CATV/DBS” to operate a CATV converter or DBS tuner.
The system will not operate normally while in CATV/DBS mode.
To turn the system power supply
ON and OFF (standby)
From the remote controls:
Press AUDIO POWER to turn power ON.
The STANDBY lamp goes off, and the current source name (or
station frequency) appears on the display window
The center unit POWER button and
0 button will light up blue.
Press AUDIO POWER again to turn power OFF (standby).
The STANDBY lamp is lit.
On the front panel:
Press POWER to turn power ON.
The STANDBY lamp goes off, and the current source name (or
station frequency) appears on the display window.
The center unit POWER button and
0 button will light up blue.
Press POWER again to turn power OFF (standby).
The STANDBY lamp is lit.
Notes:
• The powered sub-woofer power supply is linked to the center unit.
The green POWER ON lamp on the powered sub-woofer lights
when power is turned on, and goes off when power is turned off.
• A small amount of power is consumed in the standby mode.
Remove both AC power cords from the AC outlets to turn the
center unit and powered sub-woofer off completely.
To turn TV power ON and OFF
JVC TVs may be used as is with the primary and secondary remote
controls. TVs from other manufacturers require changes to the
transmittable signals before they can be used with the primary and
secondary remote controls. See page 57 for details of changing the
transmittable signals.
From the remote controls:
Press TV/CATV/DBS POWER (or TV POWER) to turn
power ON.
Press TV/CATV/DBS POWER (or TV POWER) again to turn power
OFF.
Adjusting volume
The volume level can be adjusted within the range of “0” (minimum)
to “80” (maximum).
Common:
Press VOLUME + or –.
Press VOLUME + to increase volume.
Press VOLUME – to decrease volume.
CAUTION:
Always set the volume to the minimum before starting any source.
If the volume is set at its high level, the sudden blast of sound
energy can permanently damage your hearing and/or ruin your
speakers.
Basic operations
Primary remote control Secondary remote control
AUDIO POWER AUDIO POWER
POWER
STANDBY lamp
Primary remote control Secondary remote control
TV/CATV/DBS POWER
TV POWER
Primary remote control Secondary remote control
On the front panel
VOLUME + /– VOLUME + /–
VOLUME + /–
TH-A10[J]2/1 00.2.24, 14:48 16