JVC DR-DX5SEK - Manual (Page 80)

Filename [DX5SEK_13Subsidiary.fm]
Masterpage:Left+
80
EN
SUBSIDIARY SETTINGS
Page 80Thursday, 10 November 2005 16:34
If you connect the unit and TV with Component Video Connection
(A pg. 18), you can select the scan mode from two modes:
Interlaced scan mode which is used in the conventional TV
system, and Progressive scan mode which enables reproduction of
higher-quality images.
8 Interlaced scan
In the conventional video system, a picture is shown on the display
monitor in two halves. The Interlaced scan system places lines of
the second half of the picture in-between lines of the first half of the
picture.
8 Progressive scan
Progressive scan displays all the horizontal lines of a picture at one
time, as a single frame. This system can convert the interlaced
video from DVD into progressive format for connection to a
progressive display. It dramatically increases the vertical
resolution.
1
Press HDD or DVD so that the HDD or DVD lamp lights up on
the unit.
2
Press PROGRESSIVE SCAN for 3 or more seconds.
● Video output indicator ( q) lights on the front display panel if
Progressive scan mode has been established. (A pg. 13)
● Each press of PROGRESSIVE SCAN for 3 or more seconds
switches the scan mode.
NOTES:
● When the progressive mode is set, be sure to set AL-1 OUTPUTB
to ACOMPONENTB (A pg. 64). Progressive scan is output only
from [COMPONENT VIDEO OUT] connector.
● Interlaced scan mode is the setting at your purchase.
● Interlaced scan mode might be suitable depending on video
material.
● Scan mode cannot be set while menu screen is displayed.
● When the Progressive scan mode is engaged, no video signal is
output from [L-1 IN/OUT] connector.
You can lock the disc tray to prohibit the unwanted disc ejection by
children.
To lock tray
While the unit is turned off, press and hold
o, then press M on the
unit. ALOCKB appears on the front display panel and the disc tray is
locked.
To unlock tray
While the unit is turned off, press and hold
o, then press M on the
unit. AUNLOCKB appears on the front display panel.
Scan Mode Set (HDD & DVD Deck Only)
ATTENTION:
Your TV needs to be compatible with PAL Progressive.
● Turn on the unit.
● Turn on the TV and select the AV mode.
● Slide the TV/CABLE/SAT/DVD switch to DVD.
PROGRESSIVE SCAN
DVD
HDD
CABLE/SAT
DVD TV
Tray Lock (DVD Deck Only)
● Turn off the unit.
o M
DX5SEK_00.book Page 80 Thursday, November 10, 2005 4:35 PM