JVC DR-DX5SEK - Manual (Page 66)

Filename [DX5SEK_12Editing.fm]
Masterpage:Left+
66
EN
EDITING
Page 66 Thursday, 10 November 2005 16:34
This function allows you to record new audio, without erasing the
original audio, on a DV tape that was recorded with
ADV AUDIO
REC B set to A12BITB (A pg. 72).
1
Connect an audio device to the unit’s [AUDIO] input connectors
on the front panel.
● When using a monaural audio device, connect its AUDIO OUT
connector to the [AUDIO-L] input connector on your unit.
2
Load a Mini DV cassette with the erase protection switch set to
ARECB.
3
Press DV/HDD/DVD SELECT on the unit repeatedly or DV on
the remote so that the DV lamp lights up on the unit.
4
Press PR +/– to select AF-1B.
5
Start playback slightly before the actual point from where you
wish to start dubbing.
6
Press W to pause playback.
7
Press A.DUB to engage the audio dubbing mode.
● Your unit enters the Audio Dubbing Pause mode.
● To perform Audio Dubbing with audio mixing, press AUDIO to
select
AL W X RB at this point. When using the DV deck as the
recording deck, also make sure that AAUDIO MODEB is set to
ASOUND1B (A pg. 72).
* Audio Dubbing with audio mixing is not possible if you are using a
monaural audio component, or if you don’t have an audio mixer.
8
Engage the audio device’s playback, then press I to start the
tape in the unit. Audio dubbing starts at this point.
● To stop dubbing temporarily, press W. Press I to resume
dubbing.
9
Press o on the unit, then stop playback on the audio device to
end the audio dubbing.
NOTES:
● Once the Audio Dubbing starts, you cannot use the other deck.
● When monitoring the audio dubbed sound on the DV deck, set
AAUDIO MODEB to ASOUND2B (A pg. 72).
● Audio Dubbing is also possible with the [L-1 IN/OUT] or [L-2 IN/
DECODER] connector on the rear panel. When using these 21-
pin SCART connectors, be sure to select the correct input mode
(
AL-1B or AL-2B) in step 4.
● When playing back an audio dubbed Mini DV tape on the DV
deck, set
AAUDIO MODEB to ASOUND2B (A pg. 72).
● Audio dubbing is not possible using the [DV IN/OUT] connector.
● Audio dubbing is not possible on a blank portion of the tape.
Audio Dubbing (DV Deck Only)
ATTENTION:
You cannot perform Audio Dubbing on a tape that was recorded
with
ADV AUDIO RECB set to A16BITB (A pg. 72), on a tape that
was recorded at the ALPB speed, or on a blank tape.
PR +/-
PR +/-
AUDIO OUT
Audio cable
(not supplied)
Recorder
Mixer output
To [AUDIO]
input
Your unit
A.DUB
Original sound
Audio mixer
[AUDIO OUT] Recorder Your unit
To
[AUDIO]
input
CD player, etc.
CD player, etc.
A.DUB
● Slide the TV/CABLE/SAT/DVD switch to DVD.
DX5SEK_00.book Page 66 Thursday, November 10, 2005 4:35 PM