JVC RX-F10S User Manual
Page 43
39
Operating other man
ufacturer
s’
pr
oducts
❏ Changing the transmittable signals for operating
a VCR
Set the mode selector to “AUDIO/TV/VCR/STB.”
1
Press and hold VCR
.
2
Press VCR.
3
Enter the manufacturer’s code using buttons
1 – 9, and 0.
See “Manufacturers’ codes for VCR” on the right.
4
Release VCR
.
Now, you can perform the following operation on the VCR.
VCR
:
Turn on or off the VCR.
After pressing VCR, you can perform the following operations
on the VCR.
CHANNEL +/–:
Change the channel numbers on the
VCR.
1 – 9, 0:
Select the channel numbers on the VCR.
3:
Start playback.
7:
Stop playback.
8:
Pause playback.
¡:
Fast-wind a tape.
1:
Rewind a tape.
See the instructions supplied with the VCR for details.
5
Try to operate your VCR by pressing VCR
.
When your VCR turns on or off, you have entered the correct
code.
If more than one code is listed for your brand of VCR, try each
one until the correct one is entered.
Manufacturer
Codes
JVC
01
Akai
02, 36
Bell+Howell
03, 16
Blaupunkt
04
CGM
03, 05, 16
Daewoo
34
Digtal
05
Fisher
03, 16
G.E.
06
Grundig
07
Hitachi
08, 09
Loewe
05, 10, 11
Magnavox
04, 05
Mitsubishi
12, 13, 14, 15
Nokia
16
Nordmende
17, 18, 19, 31
Orion
20
Panasonic
21
Philips
05, 22
Phonola
05
Saba
17, 18, 19, 23, 31
Samsung
24, 25
Sanyo
03, 16
Sharp
26, 27
Siemens
07
Sony
28, 29, 30, 35
Telefunken
17, 18, 19, 31, 32
Toshiba
33
Initial setting: 01
Manufacturers’ codes for VCR
Manufacturers’ codes are subject to change without
notice. If they are changed, this remote control cannot
operate the equipment.
36-40RX-F10[B]_f.p65
04.2.13, 16:41
39