Basic operations, Select the source to play, Turn on the power – JVC RX-F10S User Manual

Page 16: Selecting the analogue or digital input mode

Basic operations

Select the source to play

On the front panel:

Turn SOURCE SELECTOR until the source name
you want appears on the display.

The source lamp corresponding to the selected source lights in
red.
• As you turn SOURCE SELECTOR, the source changes as

follows:

DVD MULTI:

Select the DVD player using the analogue
discrete output mode (5.1-channel
reproduction).

DVR/DVD (DGT)

: Select the DVD recorder or DVD player.

VCR (DIGITAL)

: Select the VCR.

VIDEO (DGTL)

Select the component connected to the
VIDEO IN jacks on the rear of the receiver.

TV (DIGITAL)

Select the TV.

FM:

Select an FM broadcast.

AM:

Select an AM (MW) broadcast.

From the remote control:

Press one of the source selecting buttons.

• For the tuner, press FM/AM. Each time you press FM/AM, the

band alternates between FM and AM (MW).

* Selecting the analogue or digital input mode

For a component you have connected using both the analogue
connection and the digital connection methods (see pages 7 to 11),
you need to select the correct input mode.
• You can select the digital input only for sources which you have

selected digital input terminals for. (See “Setting the digital input
(DIGITAL IN) terminals—DIGITAL IN1/2/3” on page 21.)

From the remote control ONLY:

Press ANALOG/DIGITAL INPUT to select the
analogue or digital input mode.

• Each time you press the button, the input mode alternates

between the analogue input (“ANALOGUE”) and the digital
input (“DGTL AUTO”).

DGTL AUTO:

Select for the digital input mode. The receiver
automatically detects the incoming signal
format, then the digital signal format indicator
(LPCM, DOLBY D, DTS, or DTS 96/24) for
the detected signal lights up.

ANALOGUE:

Select for the analogue input mode.

Initial setting: ANALOGUE

NOTE

You cannot select the digital input mode when selecting “DVD
MULTI,” “FM,” or “AM” as the source.

Turn on the power

Press

STANDBY/ON (or

AUDIO on the

remote control).

The standby lamp goes off and the source lamp of the current
source lights in red.

Current source name appears.

To turn off the power (into standby)

Press

STANDBY/ON (or

AUDIO on the remote control)

again.
The standby lamp lights in red.

NOTE

A small amount of power is consumed in standby mode. To turn
the power off completely, unplug the AC power cord.

When operating the receiver
using the remote control, set
the mode selector to
“AUDIO/TV/VCR/STB.”

EQ
LPCM

LS SB RS

S . WFR

NEO : 6
DSP 3D

LFE

DOLBY D
DTS AAC
96 / 24

AUTO SR

C.TONE VIRTUAL SB AUDIO P. BASS

TA NEWS INFO RDS

TUNED ST

SLEEP

AUTO MUTING

AUTO MODE

ATT
HP

MHz

kHz