JVC RX-F10S - Manual (Page 26)

22
Sound adjustments
Sound adjustments
You can make sound adjustment to your preference after
completing basic setting.
Basic adjustment items
You can adjust the following items. See pages in parentheses for
details.
• You cannot select the items which is not available with the
current setting.
Items To do
SUBWFR LVL Adjust the subwoofer output level. (23)
FRONT L LVL* Adjust the left front speaker output level.
(23)
FRONT R LVL* Adjust the right front speaker output level.
(23)
CENTER LVL* Adjust the center speaker output level. (23)
SURR L LVL* Adjust the left surround speaker output level.
(23)
SURR R LVL* Adjust the right surround speaker output
level. (23)
S BACK LVL* Adjust the surround back speaker output
level. (23)
EFFECT Adjust the effect level. (23)
PANORAMA Add “wraparound” sound effect with side-
wall image. (23)
BASS BOOST Boost the bass level. (24)
INPUT ATT Attenuate the input level of analogue source.
(24)
CENTER TONE Make the center tone soft or sharp. (23)
D EQ 63Hz Adjust the equalization pattern of each
D EQ 250Hz band. (24)
D EQ 1kHz
D EQ 4kHz
D EQ 16kHz
CENTER GAIN Adjust the sound localization of the center
channel. (24)
SBWFR PHASE Select the subwoofer sound phase. (24)
* If you have used Smart Surround Setup on page 16, these
settings are not required.
You can also use the remote control for sound adjustment
except for the following items:
“PANORAMA,” “INPUT ATT,” “CENTER GAIN,” and “SBWFR
PHASE.”
Operating procedure
On the front panel:
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step
1 again.
Ex.: When adjusting subwoofer output level.
1
Press ADJUST.
MULTI JOG now works for the sound adjustment.
2
Turn MULTI JOG until the item you want to
adjust appears on the display.
• As you turn MULTI JOG, the adjustment items change as
follows:
3
Press SET.
The current setting for the selected item appears.
4
Turn MULTI JOG to adjust the selected item.
Your adjustment is stored.
5 Press SET.
6
Repeat steps 2 to 5 to adjust other items if
necessary.
1 2, 4 3, 5
EQ
LPCM
L
LS SB RS
S . WFR
PL
NEO : 6
DSP 3D LFE
C R
DOLBY D
DTS AAC
96 / 24
AUTO SR
C.TONE VIRTUAL SB AUDIO P. BASS TA NEWS INFO RDS TUNED ST SLEEP AUTO MUTING AUTO MODE
ATT
HP
MHz
kHz
SUBWFR LVL FRONT L LVL
SURR L LVL
S BACK LVL SURR R LVL
(Back to the beginning)
FRONT R LVL CENTER LVL
PANORAMA
EFFECT
CENTER TONE
SBWFR PHASE
D EQ 63Hz
BASS BOOST
INPUT ATT
D EQ 250Hz
D EQ 1kHz
CENTER GAIN
D EQ 4kHz
D EQ 16kHz
EQ
LPCM
L
LS SB RS
S . WFR
PL
NEO : 6
DSP 3D LFE
C R
DOLBY D
DTS AAC
96 / 24
AUTO SR
C.TONE VIRTUAL SB AUDIO P. BASS TA NEWS INFO RDS TUNED ST SLEEP AUTO MUTING AUTO MODE
ATT
HP
MHz
kHz
EQ
LPCM
L
LS SB RS
S . WFR
PL
NEO : 6
DSP 3D LFE
C R
DOLBY D
DTS AAC
96 / 24
AUTO SR
C.TONE VIRTUAL SB AUDIO P. BASS TA NEWS INFO RDS TUNED ST SLEEP AUTO MUTING AUTO MODE
ATT
HP
MHz
kHz
–10 0 +10
22-24RX-F10[B]_f.p65 04.2.13, 16:40 22