JVC RX-F10S - Manual (Page 10)

6
Getting star
ted
SUBWOOFER
OUT
CENTER SURROUND SURROUND
BACK SPEAKERS
LEFT RIGHT LEFT RIGHT
FRONT
CAUTION: SPEAKER
IMPEDANCE 6 ~ 16
L R
LS RS SB
C
SW
Connecting the speakers
Turn off all components before making connections.
1
Twist and remove the insulation at the end of each
speaker cord.
2
Press and hold the clamp of the speaker terminal
(1), then insert the speaker cord (2).
• For each speaker, connect the (+) and (–) terminals on the
rear panel to the (+) and (–) terminals marked on the
speakers.
3
Release the finger from the clamp.
CAUTIONS:
• Use speakers with the SPEAKER IMPEDANCE indicated by the
speaker terminals (6 Ω – 16 Ω).
• DO NOT connect more than one speaker to one speaker
terminal.
Connecting the speakers
Speaker Layout Diagram
Powered
subwoofer
(SW)
Surround back
speaker (SB)
1 2
1 2 3
Connecting the powered subwoofer
By connecting a subwoofer, you can enhance the bass or
reproduce the original LFE signals recorded in digital software.
Connect the input jack of a powered subwoofer to the
SUBWOOFER OUT jack on the rear panel, using a cord
with RCA pin plugs (not supplied).
• Refer also to the manual supplied with your subwoofer.
After connecting all the speakers and/or a subwoofer, set the
speaker setting information properly to obtain the best possible
surround effect. For details, see pages 16 to 19.
NOTE
You can place a subwoofer wherever you like since bass sound is
non-directional. Normally place it in front of you.
Right front speaker
(R)
Left front speaker
(L)
Right surround
speaker (RS) Left surround
speaker (LS)
Center speaker (C)
06-11RX-F10[B]_f.p65 04.2.13, 16:40 6