JVC RX-F10S - Manual (Page 42)

38
By changing the transmittable signals, you can use the
supplied remote control to operate other manufacturers’
products.
• Refer also to the manuals supplied with the other products.
• To operate those components with the remote control, first you
need to set the manufacturers’ codes each for the STB, VCR,
and TV.
• After replacing batteries of the remote control, set the
manufacturers’ codes again.
❏ Changing the transmittable signals for operating
a TV
Set the mode selector to “AUDIO/TV/VCR/STB.”
1 Press and hold TV .
2 Press TV.
3 Enter the manufacturer’s code using buttons
1 – 9, and 0.
See “Manufacturers’ codes for TV” on the right.
4 Release TV .
Now, you can perform the following operations on the TV.
TV : Turn on or off the TV.
TV VOL +/–: Adjust the volume on the TV.
TV/VIDEO: Change the input mode (either TV or
VIDEO).
After pressing TV, you can perform the following operations on
the TV.
CHANNEL +/–: Change the channel numbers.
1 – 9, 0, +10 (100+): Select the channel numbers.
See the instructions supplied with the TV for details.
5 Try to operate your TV by pressing TV .
When your TV turns on or off, you have entered the correct
code.
If more than one code is listed for your brand of TV, try each
one until the correct one is entered.
Operating other
manufacturers’
products
Operating other man
ufacturer
s’
pr
oducts
Manufacturer Codes
JVC 01
Akai 02, 05
Blaupunkt 03
Daewoo 09, 30, 31
Fenner 04, 30, 31
Fisher 05
Grundig 06
Hitachi 07, 08
Irradio 02, 05
Magnavox 09
Mitsubishi 10, 32
Mivar 03
Nokia 11, 33
Nordmende 12, 13, 17, 25, 26, 27
Orion 14
Panasonic 15, 16
Philips 09
Saba 12, 13, 17, 25, 26, 27
Samsung 09, 18, 31
Sanyo 05
Schneider 02, 05
Sharp 19
Sony 20, 21, 22, 23, 24
Telefunken 12, 13, 17, 25, 26, 27
Thomson 12, 13, 17, 25, 26, 27, 29
Toshiba 28
Initial setting: 01
Manufacturers’ codes for TV
Manufacturers’ codes are subject to change without
notice. If they are changed, this remote control cannot
operate the equipment.
36-40RX-F10[B]_f.p65 04.2.13, 16:41 38