Operation of built-in viewer (continued) – JVC VN-V25U User Manual
Page 84
84
MPEG4 Viewer Configuration
(continued)
Note:
● To use the built-in MPEG4 Viewer of VN-V25U, install “ffdshow” that is open source codec. You can
download “ffdshow” from the Internet.
Note:
● The settings of the built-in viewer are stored
in the file named Cookie.
Note:
Searching and deleting cookie files
● Open [Tool]-[Internet Options]-[Advanced]
of the Internet Explorer, and press the
[Settings] button under [Temporary Internet
Files]. A new [Settings] will appear. Press the
[View Files] button in this window. The
[Temporary Internet Files] window opens up
and a list of files will be displayed. The file
named
Acgi-binB in this list is the Cookie for
the built-in viewer.
● Deleting this file deletes the view settings,
and the viewer will be initialized during the
next startup.
Operation of Built-in Viewer
(continued)
B
Stream Settings
For specifying settings for receiving MPEG4 stream.
Stream
For selecting the protocol when the viewer acquires data from VN-V25U.
When
AHTTPB is selected, lost packets are recovered via resending.
VN-V25U may be monitored using multiple viewers when
AMulticastB is
selected.
When playing back via multicast., start multicast sending on the
[Streaming] page of the VN-V25U unit.
Caution:
● When the built-in viewer is launched with AMulticastB specified, a
Windows firewall warning may appear. In this case, select
AunblockB
and proceed.
● If AblockB is selected, the Windows firewall will block the multicast
stream and playback of multicast by the viewer will fail.
HTTP Port
You can change the HTTP port number.
The default port number setting is 80.
Specify the same value as the parameter that is set on the [Protocol]
page of VN-V25U. (
Multicast IP
Address
You can change the multicast IP address.
The default address is 225.0.2.1.
Multicast Port
You can change the multicast port number.
The default port number setting is 59152.
This is enabled when
AStartB is selected for the [MPEG4 Control] item on
the [Streaming] page.
Specify the same value as the parameter that is set on the [Streaming]
page of VN-V25U. (
C
OK
Saves the changed settings.
Click the [OK] button to enable the new settings and restart the built-in
viewer after closing the setting window.
D
Cancel
Cancels the changed settings and closes the setting screen.
This setting screen is used to set the built-in
viewer as a software on the computer, and
does not apply to settings of the VN-V25U
unit.
When settings are changed, press the [OK]
button to exit and restart the viewer.
VN-V25U_EN.book Page 84 Friday, November 2, 2007 11:26 PM