Mounting the camera, M3x6 mm – JVC VN-V25U User Manual

Page 18

Use the screw hole on the camera mounting
bracket to mount this camera to a fixer or
rotating platform.

Ⅵ Mounting the camera mounting

bracket on top of the camera

Caution:

● When mounting the camera, use screws with

a length between 5 mm to 7 mm from the
mounting surface. Screws beyond the
specified length may damage the interior,
while those shorter than specified may cause
the camera to fall off, and therefore these
must not be used.

Caution:

● The camera mounting bracket is mounted on

the top surface of the camera by default. To
mount it to the bottom surface, do so by
removing the two fastening screws from the
camera mounting bracket. Make sure to
fasten the screws firmly.

Mounting the Camera

2 mm

6 mm

M3x6 mm

Camera
Mounting
Screw Hole
1/4-20UNC

Camera Mounting
Bracket Fastening Screw
(2 pcs: M2.6 x 6 mm)

Anti-rotation Hole

Fall
Prevention
Wire

Camera
Mounting
Bracket

5 mm and
above
7 mm and
below

1/4-20UNC

VN-V25U_EN.book Page 18 Friday, November 2, 2007 11:26 PM