beautypg.com

JVC TM-1011G User Manual

Page 15

background image

15

*1 The TRIG. (trigger) system switches each function by short-circuiting for approx. 1 second.
*2 When selecting the TRIG. (trigger) system, these functions cannot be controlled if no signal is input.
*3 Tally lamp Control and External control (the 7th pin terminal) can be controlled by the MAKE (make contact) system even

when you select the “TRIG.” (trigger) system.

Operation

1. Short-circuit the 7th pin terminal (External control) to the 8th pin terminal (GND) so that the monitor can be controlled by the

external control.

2. When selecting the “MAKE” (make contact) system, operate each function by short-circuiting the corresponding pin

terminal to the 8th pin terminal (GND) or opening it.
When selecting the “TRIG.” (trigger) system, operate each function by Pulse control, that is short-circuiting the
corresponding pin terminal to the 8th pin terminal (GND) for about 1 second.

NOTES:
• When controlling INP. A or INP. B, only one terminal must be short-circuited. (Other terminals must be opened.)
• When selecting the “TRIG.” (trigger) system, you can operate only one function at a time. Operate the functions one by one.

Display

INP. A

INP. B

CO. OFF

ASPECT

TALLY

TA. SEL

STATUS

Functions to be controlled

Changes the input to INPUT A

Changes the input to INPUT B

Turns on/off COLOR OFF

Changes ASPECT

Controls the tally lamp

Selects the color of the tally lamp

Turns on/off the status display

Opening

Invalid

Invalid

Off

4:3

Off

Green

Off

Short-circuiting

Valid

Valid

On (Monochrome screen)

16:9

On

Red

On

*1

*2

*3

Functions controlled by the MAKE/TRIGGER Terminal

En_11-20_TM-1011G.p65

06.2.14, 22:37

15