JVC TM-1011G - Manual (Page 13)

13
7 BLUE CUTOFF
Adjusts the blue cut-off point.
• MIN O MAX (in 155 grades)
7 RED CUTOFF
Adjusts the red cut-off point.
• MIN O MAX (in 155 grades)
SIZE/POSI. ADJ.
Adjusts the size and
position of the picture.
7 H. SIZE
Adjusts the horizontal screen size.
• –20 O 00 O +20 (*)
–: Reduces the screen size horizontally.
+: Enlarges the screen size horizontally.
* You can adjust this item with in the range between 00
and +20 during the under-scan mode.
7 H. POSITION
Adjusts the horizontal screen position.
• –20 O 00 O +20
–: Moves the screen to the left.
+: Moves the screen to the right.
7 V. SIZE
Adjusts the vertical screen size.
• –20 O 00 O +20
–: Reduces the screen size vertically.
+: Enlarges the screen size vertically.
7 V. POSITION
Adjusts the vertical screen position.
• –10 O 00 O +10
–: Moves the screen down.
+: Moves the screen up.
DISTORTION ADJ.
Compensates the picture
distortion.
Also compensates the
picture tilt which is caused
by geomagnetic influence.
7 PARALLELOGRAM
Compensates the parallelogram picture distortion.
• –20 O 00 O +20
–: Moves the upper side of the picture to the
right, and the lower side to the left.
+: Moves the upper side of the picture to the
left, and the lower side to the right.
7 TRAPEZOID
Compensates the trapezoid picture distortion.
• –20 O 00 O +20
–: Enlarges the upper side of the picture.
+: Reduces the upper side of the picture.
7 ROTATION
Compensates a picture tilt.
• –31 O 00 O +31
–: Turns the picture clockwise.
+: Turns the picture counterclockwise.
STATUS DISPLAY
Sets the item related to
turning on/off the status
display.
7 STATUS DISPLAY
Sets the status display.
• AUTO/MANUAL/OFF
☞ “About the status display” on page 5
CONTROL LOCK
Prohibits altering the monitor operations except turning
the monitor on/off and deactivating this function.
• ON/OFF
NOTES:
• When “CONTROL LOCK” is set to “ON,” “
Control lock
on!” appears on the screen if you try to operate the monitor.
• Operating the monitor by the external control is available if
this function is activated.
all reset
Resets all the settings you have made to factory-preset
values.
• Adjustments made by using the front panel buttons
will also be reset.
1. Move the MENU/VOLUME control to / to
select “all reset,” then move it to .
Confirmation message is displayed.
2. To initialize, move the MENU/VOLUME control
to .
• To cancel the initialization, press the MENU/
VOLUME control.
En_11-20_TM-1011G.p65 06.2.14, 22:37 13