JVC KD-APD89 - Manual (Page 326)

4
Connecting the external amplifiers and/or subwoofer / /
You can connect amplifiers to upgrade your car stereo system.
• Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it
can be controlled through this unit.
• Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker
leads of this unit unused.
* 3 Remote lead
* 4 Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place uncoated with paint
(if coated with paint, remove the paint before attaching the wire). Failure to do so may cause damage to the unit.
* 5 Signal cord (not supplied for this unit)
* 6 To use these components, set the external input setting correctly (see page 25 of the INSTRUCTIONS).
•
•
* 3
* 4
* 5
* 6 25
B
Rear speakers
Remote lead (blue with white stripe)
To the remote lead of other equipment
or automatic antenna if any
Y-connector (not supplied for this unit)
Y-
Front speakers
JVC Amplifier
JVC
Set “L/O Mode” to “Woofer” (See
page 25 of the INSTRUCTIONS.)
L/O Mode
Woofer
25
You can also connect a subwoofer to
the REAR LINE OUT terminals.
REAR
LINE OUT
Set “L/O Mode” to “Rear” (See page
25 of the INSTRUCTIONS.)
L/O Mode
Rear
25
You can connect a power amplifier for
rear speakers.
JVC Amplifier
JVC
Subwoofer
JVC Amplifier
JVC
Front speakers
When connecting the external components, refer also to the manuals supplied for the components and
adapters.
CAUTION:
Before connecting the external components, make sure that the unit is turned off.
You can connect the following JVC components to the CD changer jack.
JVC component Model name
CD changer (CD-CH) CH-X1500, etc.
You can also connect the following components through the various JVC adapters.
• Connection cords may need to be purchased separately.
Component Adapter Model name
Bluetooth device Bluetooth adapter KS-BTA200
iPod Interface adapter for iPod KS-PD100
Portable audio player with line output
jacks Line input adapter KS-U57
Portable audio player with 3.5 mm
stereo mini jack AUX input adapter KS-U58
When connecting more than one component (maximum: two), it is recommended that you connect the
components in series as explained below.
Connecting the external components / C
iPod is a trademark of Apple Inc., registered in the U.S. and other countries.
CD changer jack /
CD
When connecting two components in series /
iPod Apple Inc.
JVC CD
JVC
CD CD-CH CH-X1500
JVC
•
Bluetooth Bluetooth KS-BTA200
iPod iPod KS-PD100
KS-U57
3.5 mm AUX KS-U58
To disconnect the connector /
Hold the connector tightly ( 1 ), then pull it out ( 2 ).
1 2
A KS-BTA200
B *
6 CD-CH / KS-PD100 / KS-U57 / KS-U58
* 6
or
Install3-4_KD-G845_009A_3.indd 4 Install3-4_KD-G845_009A_3.indd 4 2007.12.27 3:54:34 PM 2007.12.27 3:54:34 PM