JVC TH-V70 - Manual (Page 30)

25
Basic operations
Changing the decode mode
When you play a disc (or software) encoded with Dolby Digital or DTS Digital Surround, the following symptoms may occur:
• Sound does not come out at the beginning of playback.
• Noise comes out while searching for or skipping chapters or tracks.
In these cases, change the decode mode to “DOLBY D” (for Dolby Digital) or “DTS” (for DTS Digital Surround).
From the remote control ONLY:
Press DECODE to select the decode mode when DVD or AUX DIGITAL is selected as the source.
The current decode mode appears on the display window.
Example: When “AUTO/PCM” is selected.
Each time you press the button, the decode mode changes as follows.
] AUTO/PCM ] DOLBY D ] DTS ] (back to the beginning)
• AUTO/PCM: Normally, select this.
This system automatically detects the incoming signals.
• DOLBY D: Select this if the cases above occur when playing a disc (or software) encoded with Dolby Digital.
• DTS: Select this if the cases above occur when playing a disc (or software) encoded with DTS Digital Surround.
NOTES:
• When “DOLBY D” or “DTS” is selected, if the signal encoded with another digital format comes in, you cannot listen to the sound. ( DIGITAL
or indicator flashes.)
• Changing the source returns the decode mode to “AUTO/PCM” automatically.
L
LFE
LS RS
C R
SURROUND DIGITAL
CHANNEL VOLUME TV VOL
TUNING
STOP
DIMMER
PAUSE
FF/ /REW
TV/VIDEO
1
MUTING
¡
REC
PLAY
DOWN UP
MEMORY STROBE
DVD VCR 1
AUDIO
AUX
ANGLE
FM/AM
SUBTITLE DECODE
RETURN DIGEST ZOOM VFP
TOP MENU MENU ZOOM
CONTROL – SUBWOOFER + EFFECT
– CENTER +
– REAR-R +
TEST
SLEEP
TV
VCR
SETTING
TV RETURN
ENTER
ON
SCREEN
CHOICE
AUDIO/
TV/VCR
SURROUND
MODE
FM MODE
1 2 3
4 5 6
7 8 9
10 0 +10
100+
CATV/DBS
TV AUDIO
VCR
SOUND –
+
– REAR-L +
PROGRESSIVE
DECODE button
PROGRESSIVE (VFP) button
EN21-30TH-V70[UJ]1 02.3.26, 4:45 PM 25