JVC SP-THL1W - Manual (Page 16)

14
Operating the TV and DVD player
NOTE
• Manufacturers’ codes are subject to change without notice.
7 To set the manufacturer’s code
1
Press and hold TV.
Press and hold the button until step 3 is finished.
2
Press ENTER.
3
Press number buttons (1 - 9, 0) to
enter the manufacturer’s code (2
digits).
Examples:
For an AKAI TV: Press 0, then 2.
For a FISHER TV: Press 1, then 7.
* 01 is the initial setting.
4
Release TV.
If there is more than one code listed for corresponding
brand, try each one until you enter the correct one.
7 To operate a TV
You can perform the following operations on the TV.
NOTE
• The operating buttons may differ depending on
manufacturers.
You can use the remote control to operate not only this unit but also JVC and other manufacturers’ TV and DVD
player.
• Refer also to the manuals supplied for the TV and DVD player.
• To operate the equipment, aim the remote control directly at the remote sensor on the target equipment.
The buttons described below are used on pages 14 to
15.
Operating the TV
Number
buttons
JVC 01* PHILIPS 29
AKAI 02, 17 PIONEER 42
DAEWOO 08, 09, 29 RCA
02, 20, 46,
47, 48, 49
FISHER 17 SAMSUNG
29, 51, 52,
71, 72, 73,
74
HITACHI 24, 26 SANYO 17
IRRADIO 17 SCHNEIDER 17
MAGNAVOX 29 SHARP 54
MARANTZ 30 SONY 55
MITSUBISHI 30 TOSHIBA 53
PANASONIC 39, 41 ZENITH 69, 70
TV Turn on or off the TV.
TV/VIDEO Set the input mode (either
TV or VIDEO).
1 - 9, 0, or +100 while
pressing SHIFT Selects the channels.
RETURN while pressing
SHIFT Alternates between the
previously selected channel
and the current channel.
TV CH +/– while pressing
SHIFT Change the channels.
TV VOLUME +/– while
pressing SHIFT Adjust the volume.
TH-L1[U].book Page 14 Friday, July 13, 2007 2:22 PM