Jaguar XK JJM 18 02 30 701 - Manual (Page 58)

67
Wipers and Washers
R
CHANGING THE WIPER
BLADES
Only fit replacement wiper blades that are
identical to the original specification.
Lift the locking tab to release the blade
assembly and slide the wipe assembly off
the end of the wiper arm. Carefully
replace the wiper arm assembly to its
stowed position.
To replace the wiper blade, position the
wiper arm into the aperture in the middle
of the new blade assembly and fully
locate the blade into the wiper arm. Push
the lock tab firmly into position so that the
wiper blade is locked into the wiper arm.
WINDSHIELD WASHERS
Program wash and wipe
Timed jet function: If timed jet function is
configured, the windshield washer jets
(located on the wiper arms) only spray on
the up stroke of the wiper arms. This
function can be configured at your Jaguar
Dealer.
With the stalk in the OFF or intermittent
position, the program wash and wipe
sequence is activated by pushing the
button on the end of the column switch.
Short press: The wipers will perform five
normal speed wipes, followed by a drip
wipe. The washer jets will spray on the
first two wipes.
Extended press: The wipers and
washers will operate continuously at
normal speed until the button is released.
When released, the wipers will complete
their current wipe and then complete
three further wipes, followed by a drip
wipe.
Drip wipe: If drip wipe is configured,
following completion of the program wash
and wipe cycles, the wipers will pause for
four seconds then complete a drip wipe to
clear any remaining drips from the
windshield.
This function can be configured at your
Jaguar Dealer.
JAG0461L
JAG0125G