Jaguar XK JJM 18 02 30 701 - Manual (Page 147)

Brakes
164
L
ELECTRIC PARKING BRAKE
(EPB)
The switch which operates the parkbrake
is mounted on the centre console to the
rear of the gear selector.
To engage the parkbrake 1: Pull the
parkbrake switch upwards and release.
The switch will return to the neutral
position. The parkbrake warning/brake
fluid low warning light on the instrument
cluster will illuminate.
The Drive Away Release feature allows
the parkbrake to release automatically as
the vehicle is driven away.
To disengage the parkbrake 2: With the
ignition system in the ON position or with
the engine running, apply the foot brake
and press the parkbrake switch down.
If the parkbrake is applied while the
vehicle is stationary and D or R is
selected, applying the throttle will
automatically release the parkbrake.
The parkbrake is also automatically
released when the gear selector is moved
from the P position.
Inadvertent operation of the parkbrake
whilst the vehicle is in motion, abov
3 km/h (1.8 mph), will cause the message
PARK BRAKE APPLIED to be displayed
on the message centre, the warning light
in the instrument cluster will be
illuminated and a warning chime will
sound.
If the parkbrake is applied whilst the
vehicle is moving, releasing the switch will
disengage the parkbrake. The parkbrake
cannot be applied whilst the vehicle is
moving and the throttle pressed.
Note: If the vehicle is in motion, the
parkbrake should only be used as an
emergency brake.
Caution: Take care that the vehicle is
safely parked to prevent it from rolling
if you wish to leave the parkbrake off.
However, it is advisable to always use
the parkbrake.
The warning light in the instrument cluster
will remain on for a short time if the
parkbrake is applied when the ignition
system is reverted to the convenience
mode, see page 42.
If a fault in the system is detected, a
message PARK BRAKE FAULT or
CANNOT APPLY PARK BRAKE will be
displayed. Seek qualified assistance as
soon as possible.
If the battery has been discharged or
disconnected a message APPLYFOOT
AND PARKBRAKE will be displayed
when the ignition is next switched on.
Depress the footbrake and pull the
parkbrake switch up to apply the
parkbrake. This is required to reset the
parkbrake system. The parkbrake will
now function correctly.
JAG0045L
1 2