Jaguar XK JJM 18 02 30 701 - Manual (Page 105)

Instruments
114
L
The flashing will last for ten seconds and
then repeat every 30 seconds for
approximately five minutes or until the
belt(s) is fastened or the vehicle stops.
If the warning indicator stays ON with the
seat belt(s) fastened, report the fault to a
Jaguar Dealer. It is safe to drive the
vehicle with the light ON, provided that
the seat belt(s) is properly fastened.
Ensure that all occupants seat belts are
fastened before driving.
Note: If a heavy object is placed on the
front passenger seat it may activate the
Beltminder feature. It is recommended
that the object be placed in the luggage
compartment.
Anti-lock braking system (ABS)
(Amber)
!
WARNING:
If the ABS and brake warning
indicators are ON at the same time, do
not drive the vehicle until the fault is
rectified. Consult a Jaguar Dealer
immediately.
Illuminates if a fault has been
detected in the anti-lock brake
system (ABS) or the electric
parkbrake system. A warning message
will appear to indicate either ABS or
parkbrake fault.
The brake system will continue to function
normally, but without ABS braking.
If the indicator lamp comes on or stays on
after the bulb check cycle, the vehicle
should be driven to a Jaguar Dealer at the
earliest opportunity.
Active front lighting (Amber)
Illuminates when there is a
system fault. Report the fault to
a Jaguar Dealer as soon as
possible.
Engine malfunction (Amber)
Illuminates when the ignition
system is ON and remains on
until the engine is started.
If the indicator comes on when the engine
is running then there is an engine
malfunction.
Specialised diagnostic equipment is
required to repair such faults. Report the
fault to a Jaguar Dealer.
The vehicle may go to limp-home mode,
with the possibility of reduced engine
performance. Drive with caution.
Dynamic stability control (DSC)
(Amber)
The indicator will flash twice
every second when DSC is
operating.
The message DSC NOT AVAILABLE will
be displayed and the indicator lamp will
be ON continuously if a fault is detected.
When Trac DSC is selected the message
TRAC DSC is displayed for four seconds
and the warning indicator remains
illuminated.
DSC OFF (normally aspirated engines
only): If the system is turned OFF, a
message DSC OFF will be displayed at all
times and the warning indicator will
remain ON.
When the system is turned back ON the
warning indicator goes out and a
message DSC ON will be displayed for
four seconds.