JVC HD-61G587 - Manual (Page 61)

61
Lamp Replacement
Changing the Lamp
WARNING!
It is very important that you NEVER TOUCH THE GLASS SURFACE OF THE NEW
LAMP. Touching the glass surface will deposit oils from your hand onto the lamp
surface. When the lamp heats up to its operating temperature, the oil will cause a
difference in temperature on the lamp surface that will likely cause the lamp to break.
Replace the lamp with part number TS-CL110U only! The monitor is designed to work
specifically with this lamp. Using a different lamp, or a third-party manufacturer’s
lamp could cause a malfunction and or damage to the monitor.
This monitor uses a 110-Watt high-pressure mercury lamp to project images onto the monitor
screen. When the lamp nears the end of its operating life, you may notice the picture becoming
dark. When the picture begins to darken, or the lamp burns out, it is time to replace the lamp.
The following instructions will tell you how to safely replace the lamp.
WARNING!
Under operating conditions, THE LAMP WILL GET EXTREMELY HOT AND WILL
CAUSE SEVERE BURNS IF TOUCHED.
Before attempting to replace the lamp, make sure the monitor has completely run
through its cooling cycle. Turn the power off and wait until the LAMP LED blinks very
slowly and turns off completely. Unplug the monitor. If you feel any warmth as you
place your hand near the lamp, DO NOT TOUCH IT. Wait until the lamp has completely
cooled before attempting to replace it. After turning the power off, wait at least 1 hour
or more.
NEVER attempt to replace the lamp with the monitor plugged into a wall outlet.
Attempting to replace the lamp with the monitor plugged in could lead to a severe
electrical shock.
Do not keep the monitor on for more than 24 hours consecutively. There is the
possibility of the life of the lamp being shortened.
The life of the lamp changes depending on the atmospheric temperature and altitude
in which the monitor is being used.
Please read these instructions fully before attempting to replace the lamp. If you feel
unsure about replacing the lamp yourself, call a service technician.
LCT2065-001B-A ENG.indd 61 LCT2065-001B-A ENG.indd 61 12/18/06 10:11:13 AM 12/18/06 10:11:13 AM