JVC HM-HDS1EU - Manual (Page 77)

Masterpage:Right-Full-NoTitle0
EN
77
Filename [HDS1EU_5.fm]
Page 77 June 21, 2001 12:30 pm
VCR SET UP 2
* The default setting is bold in the table below.
8
B.E.S.T.
ON
OFF
You can set the B.E.S.T. (Biconditional Equalised Signal Tracking) system to
“ON” or “OFF” (
੬
pg. 41).
8
PICTURE CONTROL
AUTO
EDIT
SOFT
SHARP
This feature helps you to adjust the playback picture quality according to your
preference. Normally select “AUTO”.
AUTO: Provides the optimised picture benefits of the B.E.S.T. Picture
System.
EDIT: Minimizes picture degradation during editing (recording and
playback).
SOFT: Reduces image coarseness when viewing overplayed tapes
containing a lot of noise.
SHARP: Clearer, sharper-edged picture when viewing images with lots
of flat, same-coloured surfaces such as cartoons.
NOTES:
● When you select “EDIT”, “SOFT” or “SHARP”, the selected mode will not change until
you select another mode.
● When you select “EDIT” to dub tapes, be sure to select “AUTO” after you finish
dubbing the tapes.
● When “B.E.S.T.” is “OFF”, “PICTURE CONTROL” switches automatically from “AUTO”
to “NORM”.
8
DIGITAL 3R
ON
OFF
When this function is set to “ON”, the Digital 3R picture system applies edge
correction to the luminance signal to enhance detail.
NOTES:
● Normally it is recommended to keep “DIGITAL 3R” set to “ON”.
● Depending on the type of tape being used, picture quality may be better with “DIGITAL
3R” set to “OFF”.
● If you use the recorder as the source player for editing, be sure to set “DIGITAL 3R” to
“OFF” before starting.
8
DIGITAL TBC/NR
ON
OFF
Your recorder is equipped with the Digital TBC (Time Base Corrector) that
removes jitter from fluctuating video signals to deliver a stable picture even with
old tapes and rental cassettes.
The on/off of Digital 3-DNR (Noise Reduction) which cuts noise and enables
clear picture reproduction is also linked to this function.
We recommend that you set “DIGITAL TBC/NR” to “ON” when...
... playing back a tape recorded on a camcorder.
... playing back a tape repeatedly used.
... using this video recorder as the source player for editing.
NOTES:
● If you play back a tape recorded under poor TV reception condition, the picture may
become more stable with Digital TBC/NR set to off.
● When “DIGITAL TBC/NR” is set to “ON”, if you play back a tape where certain types of
signals are recorded (using a PC or some character generators), the playback picture
may be distorted. If this is the case, set “DIGITAL TBC/NR” to “OFF”.
● When playing back a MESECAM tape, Digital TBC/NR does not function even though
“DIGITAL TBC/NR” is set to “ON”.
HDS1EU_.book Page 77 Thursday, June 21, 2001 12:30 PM