JVC TH-M45 - Manual (Page 15)

Getting started
12
% Connecting the satellite (front, center, surround) speakers (TH-M65)
Each speaker (SP-THM65F) can be used as a front or surround speaker.
CAUTION
• When you connect (larger) speakers other than the supplied ones, only use speakers with the same speaker impedance (SPEAKER IMPEDANCE)
as indicated by the speaker terminals on the rear of the powered subwoofer.
• DO NOT connect more than one speaker to one speaker terminal.
Surround speakers
(SP-THM65F)
Center speaker
(SP-THM65C)
Front speakers
(SP-THM65F)
White
Black
Black
White
Red
Black
Black
Red
Powered subwoofer
Press and hold
the clamp. Insert the bare end of the
speaker cord into the
terminal. Release the
clamp.
• Connect the white cords to the red ( ª) terminals and black
cords to the black ( ·) terminals.
Route the speaker cord as shown at right.
• Be sure to remove all slack from the cord
so that the speaker cord lies flat.
Insert the speaker cords into the speaker
terminals.
Before connecting the
speaker cords;
Twist and pull the insulation coat
off and remove.
This page is for
TH-M65-55-45[J]-04Start.fm Page 12 Monday, March 24, 2003 4:34 PM