JVC TH-M45 - Manual (Page 113)

Advanced operations
42
English
Changing the VFP setting
The VFP (Video Fine Processor) function
enables you to adjust the picture character
according to the type of programming,
picture tone or personal preference.
NOTE
Before you start operation;
• The VFP setting screen disappears if no operations are done for more
than about 10 seconds. If the setting screen disappears before you
finish, start from step 1 again.
7 To select a VFP mode
1
Press VFP during playback.
The current VFP settings appear on the TV screen.
Example: When “NORMAL” is selected.
2
Press Cursor 3/2 repeatedly to select
the VFP mode.
Each time you press the button, the VFP mode changes as
follows;
O NORMAL O CINEMA O USER 1 O USER 2 O (back
to the beginning)
• NORMAL: Normally select this.
• CINEMA: Suitable for movies.
• USER 1 and USER 2:
You can adjust parameters that affect picture appearance and
store settings. Go to step 3.
NOTE
• You cannot adjust the parameters of “NORMAL” and “CINEMA”.
Press VFP to return to normal screen.
7 To adjust picture appearance manually
3
Press Cursor 3/2 repeatedly to select
“USER 1” or “USER 2”.
4
Press Cursor //5 repeatedly to select a
parameter you want to adjust.
Adjust gradually and confirm picture appearance results are as
preferred.
• GAMMA (–4 to +4):
Controls brightness of neutral tints while maintaining
brightness of dark and bright portions.
• BRIGHTNESS (–16 to +16):
Controls screen brightness.
• CONTRAST (–16 to +16):
Controls screen contrast.
• SATURATION (–16 to +16):
Controls screen color depth.
• TINT (–16 to +16):
Controls screen tint.
• SHARPNESS (+0 to +3):
Controls screen sharpness.
• Y DELAY (–2 to +2):
Controls screen color gap.
5
Press ENTER.
VFP menu disappears and the following pop-up window
appears on the TV screen.
6
Press Cursor //5 repeatedly to change
the setting.
7
Press ENTER.
The current VFP settings appear again.
8
Repeat steps 4 to 7 to adjust other
parameters.
To return to the normal screen
Press VFP.
To activate your setting
Press VFP, then press Cursor 3/2 repeatedly to select “USER 1”
or “USER 2” that you have changed the parameters.
TH-M65-55-45[C].book Page 42 Tuesday, April 1, 2003 10:11 AM