JVC CA-V888T - Manual (Page 21)

17
English
LVT0024-001A
[ U, UF ]
Tuning in a Station
Press the FM/AM button (or the TUNER button on the Remote Control) to turn on the radio.
The Frequency of the previously selected channel appears on the display.
Switching between Frequency Bands —————————————————
Press the FM/AM button.
Each time you press the button, the band alternates between FM and AM.
Selecting a Radio Station —————————————————————
❏ Select a frequency by adjusting the MULTI CONTROL stick up or down. The frequency
changes in one step increments. “TUNED” appears on the display when a signal is found. This
is called Manual Tuning.
The frequency increases when MULTI CONTROL stick is pressed upwards, and decreases
when the MULTI CONTROL stick is pressed downwards.
❏ If the MULTI CONTROL stick is pressed up or down continuously for a few seconds, the
frequency changes continuously until a signal is found, then “TUNED” appears on the display.
This is called Auto Tuning.
❏ Possible only after presetting stations.
Using the Unit
Select a preset channel by adjusting the MULTI CONTROL stick left or right.
Using the Remote Control
1. Press the TUNER button so that you can receive the most recent station tuned in.
2. Select the station by entering the preset number in the number keys of the Remote Control.
❏ Example: for channel 5, press 5. For channel 15, press +10 then 5. For channel 20, press
+10, then 10. For channel 32, press +10 three times, then 2.
Presetting Stations
You can store up to 40 of your favorite radio stations (FM and AM) in memory, giving you quick,
easy access to the stations.
Note: In some cases, test frequencies have been already memorized for the tuner since the factory
examined the tuner preset function before shipment. This is not a malfunction. You can preset the
stations you want into memory by following the presetting method.
1.
Select a frequency band by pressing the FM/AM button.
2.
Tune to a station by adjusting the MULTI CONTROL stick up or down.
3.
Press the SET/DEMO button.
On the display, “SET” will blink for 5 seconds.
❏ During these 5 seconds while “SET” is blinking, you can assign a channel number to the
station and enter it into the memory as follows.
4.
Select a preset number by adjusting the MULTI CONTROL stick left or right.
5.
Press the SET/DEMO button and the station will be assigned to the channel number showing on
the display.
“MEMORY” appears in the display.
❏ If a station has been previously stored using the same channel number, this will be erased
and the newly selected station will be stored.
❏ If “SET” in the display goes off, start again from step 3.
TUNER
FM/AM
1
2
3
4
5
FM/AM
SET
/
SET
/