JVC CA-V888T - Manual (Page 16)

12
English
LVT0024-001A
[ U, UF ]
Using a VCR
Listening to a VCR ————————————————————————
By playing the sound from VCR through the CA-V888T, you can gain control over how the music
or program sounds. Once the connected equipment is playing through the CA-V888T, you can apply
the sound mode effects.
❏ First make sure that the optional equipment is properly connected to the CA-V888T. (See page 6.)
1.
Set the VOLUME control to 0.
2.
Press the VCR button.
When CA-V888T is in Standby mode, the Unit is automatically turned on and “VCR” appears
on the display.
3.
Start playing the equipment.
4.
Adjust the VOLUME control to the desired listening level.
5.
Select a sound effect mode, if you wish.
To Cancel the Setting
Change the source by starting any one of the CA-V888T’s built-in sound sources, such as the Tuner
or Video CD Player.
Recording to a VCR ————————————————————————
To record audio to a VCR, start playback of the recording source of the CA-V888T and start
recording on your VCR. (Refer to the VCR’s instruction manual for details on the recording
procedure for your VCR.)
❏ You cannot record using SEA mode effects.
Reinforcing the Bass Sound
The richness and fullness of the bass sound is maintained regardless of how low you set the volume.
You can use this effect only for playback.
To get the effect, press the ACTIVE BASS EX. (Active Bass Extension) button. “BASS ON”
appears in the display and the indicator lights up.
To cancel the effect, press the button again. The message “OFF” appears in the display and the
indicator goes out.
VCR
ACTIVE
BASS EX.
Using the Microphone
The CA-V888T includes two microphone terminals, MIC 1 and MIC 2. By attaching a microphone
to one or both of these terminals, you can use the CA-V888T for Karaoke or microphone mixing.
You can also add an echo to the microphone’s sound.
❏ The MIC LEVEL control adjusts the volume for both MIC 1 and MIC 2 at the same time.
❏ When you will not be using the microphone, keep the MIC LEVEL control set to MIN, and
disconnect the microphone.
CAUTION: Always set the MIC LEVEL control to MIN when connecting or disconnecting the microphone.
Indicator