JVC CA-V888T - Manual (Page 15)

11
English
LVT0024-001A
[ U, UF ]
Customizing a Sound Mode —————————————————————
You can change an existing sound mode to suit your own preferences. These changed setting can be
stored in the CA-V888T’s sound mode memory.
1.
Select the sound mode you want to change.
2.
Press the SEA CONTROL button.
“SEA CONT” appears on the display, then the low tone section of the tone equalizer is dis-
played and the MULTI CONTROL indicators light up to indicate the directions in which you
can use the MULTI CONTROL stick. The surround effect of the selected sound mode remains
unchanged.
Note: If no adjustments are made for 8 seconds after the SEA CONTROL button is pressed, Sound
mode appears on the display then reverts to the previous display.
3.
Adjust the settings using the MULTI CONTROL stick.
❏ Adjust the level by adjusting the MULTI CONTROL stick up and down.
The level can be set between +3 and –3 in seven steps.
❏ Select the tone range by adjusting the MULTI CONTROL stick left and right.
You can select LOW, MID, or HIGH tone.
4.
Press the SET/DEMO button.
“MANUAL 1” appears on the display.
5.
Select the memory number by adjusting the MULTI CONTROL stick left and right.
You can choose from “MANUAL 1” to “MANUAL 3”.
6.
Press the SET/DEMO button again.
“MEMORY” appears on the display and the settings are stored in the memory number selected.
❏ The sound mode is set to the settings you have stored.
❏ If you store new settings to a memory number that has already been used, the new settings
replace the existing setting.
SOUND MODE
SEA CONTROL
TIMER/CLOCK
SOUND MODE
1 2 3 4
5 6 7
VOL
SOUND MODE
1 2 3 4
5 6 7
VOL
SOUND
MODE
1 2 3 4
5 6 7
VOL
SOUND
MODE
1 2 3 4
5 6 7
VOL
SOUND
MODE
1 2 3 4
5 6 7
VOL
SET
SOUND
MODE
1 2 3 4
5 6 7
VOL
CD
SET
/
SET
/