beautypg.com

JVC 0303-MK-ID-SN User Manual

Page 49

background image

EN

49

CAUTIONS

5. Dirty heads can cause the following problems:

• No picture during playback.
• Blocks of noise appear during playback.
• During recording or playback, the Head Clog

Warning indicator “

” appears.

• Recording cannot be performed properly.

In such cases, use an optional cleaning cassette.
Insert it and play back. If the cassette is used more
than once consecutively, damage to the video heads
may result. After the camcorder plays back for about
20 seconds, it stops automatically. Also refer to the
cleaning cassette’s instructions.
If, after using the cleaning cassette, the problems
still exist, consult your nearest JVC dealer.
Mechanical moving parts used to move the video
heads and video tape tend to become dirty and worn
out over time. In order to maintain a clear picture at
all times, periodic check-ups are recommended after
using the unit for about 1,000 hours. For periodic
check-ups please consult your nearest JVC dealer.

Built-in Clock’s Rechargeable Lithium Battery

To store the date/time in memory, the clock’s recharge-
able lithium battery is integrated in the camcorder.
While the camcorder is connected to an AC outlet
using the AC Adapter, or while the battery pack
attached to the camcorder continues to supply power,
the clock’s rechargeable lithium battery is always
charged. However, if the camcorder is not used for
approx. 3 months, the clock’s lithium battery will
become discharged and the date/time stored in
memory will be lost. When this occurs, first connect the
camcorder to an AC outlet using the AC Adapter for
over 24 hours to charge the clock’s rechargeable
lithium battery. Then perform the date/time setting
before using the camcorder.

Note that the camcorder can be used without setting
the date/time.

How to handle a CD-ROM

• Take care not to soil or scratch the mirror surface

(opposite to the printed surface). Do not write anything
or put a sticker on either the front or back surface. If
the CD-ROM gets dirty, gently wipe it with a soft cloth
outward from the centre hole using a circular motion.

• Do not use conventional disc cleaners or cleaning

spray.

• Do not bend the CD-ROM or touch its mirror surface.
• Do not store your CD-ROM in a dusty, hot or humid

environment. Keep it away from direct sunlight.

LCD Monitor

1. To prevent damage to the LCD monitor,

DO NOT . . .
... push it strongly or apply any shocks.
... place the camcorder with the LCD monitor on the

bottom.

2. To prolong service life . . .

... avoid rubbing it with coarse cloth.

3. Be aware of the following phenomena for LCD

monitor use.
These are not malfunctions:
• While using the camcorder, the surface around the

LCD monitor and/or the back of the LCD monitor
may heat up.

• If you leave power on for a long time, the surface

around the LCD monitor becomes hot.

Main Unit

1. For safety, DO NOT . . .

... open the camcorder’s chassis.
... disassemble or modify the unit.
... short-circuit the terminals of the battery pack.

Keep it away from metallic objects when not in
use.

... allow inflammables, water or metallic objects to

enter the unit.

... remove the battery pack or disconnect the power

supply while the power is on.

... leave the battery pack attached when the

camcorder is not in use.

2. Avoid using the unit . . .

... in places subject to excessive humidity or dust.
... in places subject to soot or steam such as near a

cooking stove.

... in places subject to excessive shock or vibration.
... near a television set.
... near appliances generating strong magnetic or

electric fields (speakers, broadcasting antennas,
etc.).

... in places subject to extremely high (over 40

°C) or

extremely low (under 0

°C) temperatures.

3. DO NOT leave the unit . . .

... in places of over 50

°C.

... in places where humidity is extremely low (below

35%) or extremely high (above 80%).

... in direct sunlight.
... in a closed car in summer.
... near a heater.

4. To protect the unit, DO NOT . . .

... allow it to become wet.
... drop the unit or strike it against hard objects.
... subject it to shock or excessive vibration during

transportation.

... keep the lens directed at extremely bright objects

for long periods.

... expose the lens to direct sunlight.
... carry it by holding the LCD monitor or the

viewfinder.

... swing it excessively when using the strap or the

grip.

This manual is related to the following products: