JVC 0303-MK-ID-SN - Manual (Page 38)

EN
38 DUBBING
Dubbing To Or From A Video Unit
Equipped With A DV Connector
(Digital Dubbing)
It is also possible to copy recorded scenes from this
camcorder onto another video unit equipped with a DV
connector. Since a digital signal is sent, there is little if
any image or sound deterioration.
To Use This Camcorder As A Player
1
Make sure all units are turned off. Connect this
camcorder to a video unit equipped with a DV input
connector using a DV cable as shown in the illustration.
2
Set this camcorder’s VIDEO/MEMORY Switch t to
“VIDEO”, then the Power Switch @ to “ ” while
pressing down the Lock Button $ located on the
switch, turn on the video unit’s power, and insert the
appropriate cassettes in this camcorder and the video
unit.
3
Press 4 ! to play back the source tape.
4
While watching the playback on the monitor, engage
the DV connector-equipped video unit’s record mode
from the spot on the source tape you want to begin
recording.
NOTES:
● It is recommended to use the AC Adapter as the
power supply instead of the battery pack (
੬
pg. 7).
● If the remote control is used when both the player and
recorder are JVC video units, both units will perform the
same operation. To prevent this from happening, press
the buttons on both units.
● If a blank portion or disturbed image is played back on
the player during dubbing, the dubbing may stop so that
an unusual image is not dubbed.
● Even though the DV cable is connected correctly,
sometimes the image may not appear in step 4. If this
occurs, turn off the power and make connections again.
● If “Playback Zoom” ( ੬
pg. 13, 39), “Playback Special
Effects” (
੬
pg. 39) or “Snapshot” is attempted during
playback, only the original playback image recorded on
the tape is output from the DV connector
) .
● When using a DV cable, be sure to use the optional
JVC VC-VDV204U DV cable.
To Use This Camcorder As A Recorder
1. Set this camcorder’s VIDEO/MEMORY Switch t to
“VIDEO”, then the Power Switch @ to “ ” while
pressing down the Lock Button $ located on the
switch.
2. Set “REC MODE” to “SP” or “LP” in the Menu
Screen (
੬
pg. 35).
3. Connect the DV cable as shown in the illustration
and load a cassette to record on.
4. Press START/STOP k on the remote control to
engage the Record-Pause mode. “ DV. IN ” appears
on the screen.
@
$
!
t
DV cable
(optional)
Video unit equipped
with DV connector
To DV IN/OUT
To DV
)
Core filter
Core filter
5. Press START/STOP k on the remote control to
start recording. 4 rotates.
6. Press START/STOP k on the remote control
again to engage the Record-Pause mode. 4
stops rotating.
NOTES:
● Digital Dubbing is performed in the sound mode recorded
on the original tape, regardless of the current “SOUND
MODE” setting (
੬
pg. 32).
● During Digital Dubbing, incoming signals cannot be
output through the video or audio connectors if they are
copy-guarded.