JVC 0303-MK-ID-SN - Manual (Page 30)

EN
30 FOR RECORDING
Manual Focus
To obtain correct focus.
1
If you are using the viewfinder, you should already
have made the necessary viewfinder adjustments
(
੬
pg. 8).
2
Set the Power Switch @ to “ ” while pressing
down the Lock Button $ located on the switch, then
press FOCUS r (
੬
pgs. 52 and 53). The manual
focus indicator appears.
3
To focus on a farther subject, press + 5 . “ ” R
appears and blinks.
To focus on a nearer subject, press –
5 . “ ” R
appears and blinks.
4
Press SELECT/SET 3 . Focus adjustment is
complete.
To reset to Auto Focus, press FOCUS r twice or set
the Power Switch @ to “ ”.
If FOCUS r is pressed once, the camcorder will enter
the focus adjustment mode again.
NOTES:
● Be sure to focus the lens in the maximum telephoto
position when you use the Manual Focus mode. If you
focus in on a subject in the wide-angle position, sharply
focused images cannot be obtained when zoomed up
because the depth-of-field is reduced at longer focal
lengths.
● When the focus level cannot be adjusted any further or
closer, “ ” or “ ” will blink.
Exposure Control
Manual exposure adjustment is recommended in the
following situations:
• When shooting using reverse lighting or when the
background is too bright.
• When shooting on a reflective natural background
such as at the beach or when skiing.
• When the background is overly dark or the subject
light.
1
Set the Power Switch @ to “ ” while pressing
down the Lock Button $ located on the switch. Open
the LCD monitor fully or pull out the viewfinder fully.
2
Press MENU 4 . The Menu Screen appears.
3
Press + or – 5 to select “ (EXPOSURE)”, then
press SELECT/SET 3 .
4
Press + or – 5 to select “MANUAL”, then press
SELECT/SET 3 . The Menu Screen disappears. The
exposure control indicator appears.
5
Press + 5 to brighten the image, or – 5 to darken
the image. (maximum ±6)
6
Press SELECT/SET 3 . Exposure adjustment is
complete.
To Return To Automatic Exposure Control . . .
..... select “AUTO” in step 4. Or, set the Power Switch
@ to “ ”.
To Brighten The Subject Quickly . . .
..... press BACKLIGHT w . r is displayed and the
subject is brightened. If pressed again, r
disappears and the brightness returns to the
previous level.
• +3 exposure has the same effect as the BACKLIGHT
Button w .
• Using BACKLIGHT w may cause the light around the
subject to become too bright and the subject to
become white.
• Backlight compensations is also available when the
Power Switch @ is set to “ ”.
NOTE:
You cannot use the manual exposure control at the same
time with backlight, spotlight (
੬
pg. 27) compensation and
“SNOW” (
੬
pg. 27).
While focusing on
a nearer subject While focusing on
a further subject
Focus detection zone