JVC DR-M100S - Manual (Page 12)

Filename [M100SEK_05Name.fm]
Masterpage:Left+
12
EN
INDEX
Rear View
A Antenna Input Connector [ANTENNA IN] A pg. 17
B Component Video Output Connectors [COMPONENT
VIDEO OUT (Y/P B /P R )] A pg. 17
C L-1 Input/Output Connector [L-1 IN/OUT] A pg. 17, 57, 58,
60, 61
D L-2 Input/Decoder* Connector [L-2 IN/DECODER] A pg. 57,
58, 60, 61
* The decoder function of this unit is not available in the U.K.
E Audio Output Connector [AUDIO OUT LEFT/RIGHT]
A pg. 17
F Digital Audio Output Connector [DIGITAL OUT (COAXIAL)]
A pg. 55, 61
G Region Number
H AC Power Cord
I Antenna Output Connector [ANTENNA OUT] A pg. 17
J Cooling Fan
● This prevents the temperature from rising inside the unit.
Do not remove it.
● Install the unit so as not to block the area around the fan.
● The unit may become hot when it is turned off, as the cooling
fan on the rear of the unit is not activated. However, the cooling
fan may be activated in the following cases;
^ In the Automatic Satellite Programme Recording standby
mode (A pg. 43), slightly before the starting time of VPS/
PDC recording (A pg. 39).
^ If you connect the decoder or satellite receiver to [L-2 IN/
DECODER], and if AL-2 SELECTB is set to ADECODERB,
ASAT VIDEO/RGBB or ASAT S-VIDEO/RGBB. (A pg. 59)
^ When AJUST CLOCKB is set to AONB (A pg. 69)
(Set AJUST CLOCKB to AOFFB if you mind the noise of the
fan.)
A B C E G
J
H
I
F D
M100SEK_00.book Page 12 Tuesday, March 22, 2005 5:31 PM