John Lewis JLDWS 907 - Manual (Page 30)

30
Electrical connection
Warning! Safety standards require
the appliance to be earthed. Prior to
using the appliance for the first time,
ensure that the rated voltage and
type of supply on the rating plate
match that of the supply where the
appliance is to be installed. The fuse
rating is also to be found on the
rating plate. Always plug the mains
plug into a correctly installed
shockproof socket. Multi-way plugs,
connectors and extension cables
must not be used. This could
constitute a fire hazard through
overheating. If necessary, have the
domestic wiring system socket
replaced. In case that the electrical
cable has to be replaced, contact
your local repair agent. The plug
must be accessible after the
appliance has been installed. Never
unplug the appliance by pulling on
the cable. Always pull the plug. The
manufacturer accepts no liability for
failure to observe the above safety
precautions.
Fuse replacement
If the mains lead of this appliance is fitted
with a BS 1363A 13amp fused plug, to
change a fuse in this type of plug use an
A.S.T.A. approved fuse to BS 1362 type and
proceed as follows:
1. Remove the fuse cover A and fuse B.
2. Fit replacement 13A fuse into fuse cover.
3. Refit both into plug.
Warning! The fuse cover must be
refitted when changing a fuse and if
the fuse cover is lost the plug must
not be used until a correct
replacement is fitted. Correct
replacement are identified by the
colour insert or the colour
embossed in words on the base of
the plug. Replacement fuse covers
are available from your local
electrical store.