John Lewis JLDWS 907 - Manual (Page 22)

22
Cleaning the filters
• The central filter H should be inspected
regularly and cleaned if necessary. To
remove it, take hold of the handle, turn
anti-clockwise and lift.
• Press the central filter H from below to
extract it from the micro-filter.
• Separate the two parts of the plastic filter
by pressing the body of the filter in the
zone shown by the arrows.
• Remove the central filter by lifting it.
NEVER use the dishwasher
without filters.
Incorrect repositioning and fitting of
the filters will produce poor washing
results and will result in damage to
the appliance.
External cleaning
Clean the external surfaces of the machine
and control panel with a damp soft cloth. If
necessary use only neutral detergents.
Never use abrasive products, scouring pads
or solvent (acetone, trichloroethylene
etc...).
Internal cleaning
Ensure that the seals around the door, the
detergent and rinse aid dispensers are
cleaned regularly with a damp cloth.
We recommend every 3 months you run
the wash programme for heavy soiled
dishes using detergent but without dishes.
Prolonged periods of non-
operation
If you are not using the machine for a
prolonged period of time you are advised
to:
1. Unplug the appliance and then turn off
the water.
2. Leave the door ajar to prevent the
formation of any unpleasant smells.
3. Leave the inside of the machine clean.
Frost precautions
Avoid placing the machine in a location
where the temperature is below 0°C. If this
is unavoidable, empty the machine, close
the appliance door, disconnect the water
inlet pipe and empty it.
Moving the machine
If you have to move the machine (moving
house, etc...):
1. Unplug it.
2. Turn the water tap off.
3. Remove the water inlet and discharge
hoses.
4. Pull the machine out together with the
hoses.
Avoid over tilting the machine during
transportation.