John Lewis JLDWS 907 - Manual (Page 26)

26
For the installer
Technical data
Installation
Warning! It is dangerous to alter
the specifications or attempt to
modify this product in any way. This
appliance is heavy. Care should be
taken when moving it. Care must be
taken to ensure that the appliance
does not stand on the electrical
supply cable. Any electrical work
required to install this appliance
must be carried out by a qualified
electrician or competent person.
Any plumbing work required to
install this appliance must be carried
out by a qualified plumber or
competent person.
Unpacking
• Remove all packaging before positioning
the machine.
• If possible, position the machine next to a
water tap and a drain.
Fitting under a counter
(Kitchen worktop or sink)
To build in the dishwasher, the special kit
must be purchased from authorised dealers
or the After-Sales Service.
By removing the machine’s worktop, you
can install it under a close fitting sink unit or
a preexisting top, providing the dimensions
of the recess correspond to those shown in
the picture.
Width 447 ÷ 449 mm
Depth measured flush with the
outer edge of the control panel
593 mm
Height from 820 mm to 890 mm
Capacity 10 Standard place settings
Water supply pressure min. 0,05 - max. 0,9 MPa (min. 0.5 – max. 9 bar)
Electrical characteristics See rating plate