John Lewis JLDWS 907 - Manual (Page 23)

23
Something not working
The dishwasher will not start or stops
during operation. Certain problems are due
to the lack of simple maintenance or
oversights, which can be solved with the
help of the indications described, without
calling out an engineer.
Switch off the appliance and carry out the
following suggested corrective actions.
Important! If you call out an
engineer to a fault listed below, or
to repair a fault caused by incorrect
use or installation, a charge will be
made even if the appliance is under
guarantee.
Warning! Any operations
performed on the appliance by
unauthorised persons are not
covered by the warranty and shall be
paid for by the user.
If an alarm occurs the appliance interrupts
the programme in progress and signals a
fault.
• Alarms E1, E2, E3, E4, E8 and E9 interrupt
the current programme immediately.
• The E5, E6 alarms interrupts the running
programme once the cause is resolved, it
will bring bach the execution of the
programme.
• The alarm E7 is visualized at the end of the
cycle that comes, however, brought to the
end since the operation of the dishwasher
is not harmed.
To "reset" an alarm is necessary:
• Open and close the door, or turn off and
on the machine. At this point is possible to
programme the dishwasher again.
The dishwasher is capable of signalling a
number of faults through the simultaneous
illumination of several indicator lights, with
the following meanings:
E1 - Acquastop failure
The anti-flooding system has been activated
(for the relevant models only). The system
is tripped in case of water leaks. Contact
the after-sales service.
E2 - Safety level
The system which limits the water level
inside the dishwasher has been tripped.
Interrupt the programme and switch off the
dishwasher. Switch the dishwasher back on,
programme it again and start the washing
cycle. If the problem persists, contact the
after-sales service.
E3 - Water heating malfunction
The water is not heated or the heating
parameters are not correct. Repeat the
washing programme; if the problem
persists, contact the after-sales service.
Light flashing
Light off
Light on
-end-
Rinse
hold
Quick
wash
Economy
50°
Auto Intensive
70°
-end-
Rinse
hold
Quick
wash
Economy
50°
Auto Intensive
70°
-end-
Rinse
hold
Quick
wash
Economy
50°
Auto Intensive
70°