John Lewis JLDWS 907 - Manual (Page 27)

27
Proceed as follows:
Remove the machine’s worktop by
unscrewing the two rear retaining screws
(1), pull the worktop from the back of the
machine (2) and slide out the front slots,
lifting the worktop (3). Insert the machine after adjusting the
levelling with the adjustable feet. When
inserting the machine, ensure that the
water inlet and drain hoses are not kinked
or squashed.
During all operations that involve
accessibility to internal components the
dishwasher has to be unplugged.
Be sure that once the appliance has been
installed, it is easily accessible for the
service engineer in the event that a repair is
required.
If the dishwasher is later used as a free-
standing appliance, the original worktop
must be re-mounted.
The plinth on free-standing appliances is not
adjustable.
Levelling
Good levelling is essential for correct
closure and sealing of the door. When the
appliance is correctly levelled, the door will
not catch on either side of the cabinet. If
the door does not close correctly, loosen
or tighten the adjustable feet until the
machine is perfectly level.