John Lewis JLDWS 907 - Manual (Page 21)

21
Maintenance and cleaning
Cleaning the water intake
filter
Warning! Before carrying out any
work, always unplug the appliance
from the electrical supply or switch
off the all-pole disconnection device.
The water intake filter A located at the
outlet of the water supply tap needs to be
cleaned periodically.
After having closed the water supply tap,
unscrew the end of the water intake hose,
remove the filter A and clean it delicately
under running water. Reassemble filter A in
its seat and carefully screw the water intake
hose back into position.
Cleaning the spray arms
The spray arms can be easily removed for
periodic cleaning of the nozzles, to prevent
possible clogging. Wash them under
running water and carefully replace them in
their seats, checking that their rotary
movement is in no way impeded.
To remove the upper spray arm, unscrew
locking ring R.
Cleaning the spray arm,
travelling version
To remove the TRAVELLING spray arm,
take hold of it and raise it to release both
the spray arm and the pipe from the tank,
then detach the spray arm from the pipe.
Wash both the pipe and the spray arm in
running water, re-attach the spray arm to
the pipe and return the assembly to the
seat provided in the tank.
Once the assembly has been put back in
place, check that the spray arm turns freely
(turn through a couple of revolutions by
hand) and that the pipe is able to travel
without impediments. Otherwise, check
that it has been fitted correctly.