JVC CA-MXJ100 - Manual (Page 18)

– 13 –
English
Basic CD Operations
While playing a CD, you can do the following operations.
To exchange CDs during playback of another
Press DISC CHANGE to eject and exchange the CD.
To locate a particular point in a track
During play, press and hold 1 or
¡.
•
1 : Fast reverses the disc.
•
¡ : Fast forwards the disc.
When using the remote control, press
and hold
4 / 1 or ¢ / ¡.
To go to another track
Press
4 or ¢ repeatedly before
or during playback.
•
4: Goes back to the beginning of
the current or previous tracks.
•
¢: Skips to the beginning of the
next or succeeding tracks.
When using the remote control, press 4 / 1 or ¢ / ¡
before playing.
If you press and hold 4 / ¢ on the unit
You can change the tracks continuously.
Programming the Playing Order of the Tracks
— Program Play
You can arrange the order in which the tracks play before you
start playing. You can program up to 24 tracks.
• To repeat the program, select “REPEAT ALL CD” by
pressing REPEAT repeatedly.
1
Load discs.
• If the current playing source is not the CD player, press
CD
6, then 7 before going to the next step.
2
Press PROGRAM/SET.
3
Select the disc number.
On the unit:
Press one of the disc number
buttons (CD 1, CD 2, and CD
3).
On the remote control:
Press DISC SKIP repeatedly.
4
Press
4 or ¢ (4 / 1 or ¢ / ¡ on
the remote control) to select the track
number, then press PROGRAM/SET.
5
Program other tracks you want.
• To program tracks from the same disc, repeat step 4.
• To program tracks from a different disc, repeat steps 3
and 4.
6
Press CD
6.
The tracks are played in the order you have programed.
To add more tracks into the program
Press PROGRAM/SET.
You can add the tracks into the program before or after play.
If you have already programed all 24 tracks, you cannot add
more. If you do, it will overwrite the 1st track and so on.
• You cannot erase or modify the programmed tracks.
• If you want to modify the program, erase all the program and start
from the beginning.
To stop during play, press 7.
To erase the entire program before or after play, press 7.
• Ejecting the Carousel will also erase the program.
If your entry is ignored
You have tried to program a track from an empty tray, or a track
number that does not exist on the CD (for example, selecting track
14 on a CD that only has 12 tracks). Such entries are ignored.
Disc number Program step number
Track number
PROGRAM/SET
PROGRAM/SET
Program step number Disc number
2
1 3
PRGM
2
1 3
PRGM
Corresponding
disc number
flashes
Corresponding
disc number
flashes
CD 1 CD 2 CD 3
TUNING + - TUNING
DISC SKIP
EN12-14.CA-MXJ100[E]/f 00.4.3, 11:55 AM 13