JVC CA-MXJ100 - Manual (Page 14)

– 9 –
English
Common Operations
Setting the Clock
Before operating the unit any further, first set the clock built
in this unit.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
• If you want to stop clock setting, press CLOCK/TIMER
once or wait until the time limit of 15 seconds comes.
1
Press CLOCK/TIMER twice.
The “CLOCK” appears on the display.
2
Press PROGRAM/SET.
The hour digits start flashing on the
display.
3
Press
4 or ¢ to adjust
the hour, then press
PROGRAM/SET.
After hour digits are set, the
minute digits start flashing on the
display.
4
Press
4 or ¢ to adjust
the minute, then press
PROGRAM/SET.
5
Press CLOCK/TIMER twice to
finish the clock setting.
To check the clock time
Press CLOCK/TIMER while playing any source.
The clock time appears on the display
for a while.
Turning On the Power and Selecting the
Sources
When you press the play button for a particular source (AUX,
FM/AM, CD
6, and TAPE 3), the unit turns on (and the
unit starts playing the source if it is ready — COMPU PLAY
CONTROL).
To listen to the FM, MW, or LW broadcasts, press
FM/AM. (See page 11.)
To play back CDs, press CD
6. (See pages 12 and 13.)
To play back tapes, press TAPE 3. (See page 14.)
To select the external equipment as the source, press AUX.
To turn on the unit without playing, press
(standby/on) so that the STANDBY lamp
goes off.
To turn off the unit (on standby), press
(standby/on) again so that the STANDBY lamp
lights up.
A little power is always consumed even while the unit is on
standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to “0:00” right away, while the tuner preset
stations (see page 11) will be erased in a few days.
CLOCK/TIMER
PROGRAM/SET
FM/AM AUX TAPE
STANDBY
PROGRAM/SET
PROGRAM/SET
CD
STANDBY
To adjust the clock again
If you have adjusted the clock before, you need to press
CLOCK/TIMER until the “CLOCK” is selected.
• Each time you press the button, the clock/timer setting
modes change as follows:
If there is a power failure
The clock loses the setting and is reset to “0:00.” You need to set the
clock again.
CLOCK/TIMER
TIMER
CLOCK Clock time
REC
CLOCK/TIMER
EN01-11.CA-MXJ100[E]/f 00.5.10, 0:39 PM 9