JVC 1001MKV*UN*SN - Manual (Page 7)

7
Y
M
D
T
E
E
O
A
I
X
A
N
Y
M
I
R
T
E
T
H
DATE / T I ME
2
2
0
0
:
0
2
2
2
6
8
0
1
@
• During charging or discharging, the camcorder
cannot be operated.
• Charging and discharging is not possible if the
wrong type of battery is used.
• When charging the battery pack for the first time
or after a long storage period, the CHARGE lamp
*
may not light. Remove the battery pack from
the camcorder, then try charging again.
• If a fully-charged battery’s operation time remains
extremely short, the battery is worn out. Please
purchase a new one.
• Perform charging where the temperature is
between 10°C and 35°C. 20°C to 25°C is the ideal
temperature range for charging. If the environment
is too cold, charging may be incomplete.
• Charging time varies according to the ambient
temperature and the status of the battery pack.
• Since the AC Adapter processes electricity
internally, it becomes warm during use. Be sure to
use it only in well-ventilated areas.
• The following operation stops charging or
discharging:
• Set the Power Switch
@
to “ ”, “ ” or “ ”.
• Disconnect the AC Adapter from the camcorder.
• Unplug the AC Adapter’s power cord from the
AC outlet.
• Detach the battery from the camcorder.
• Using the optional AA-V15 AC Power Adapter/
Charger, you can charge the BN-V11U/V12U/
V20U/V400U battery pack without the camcorder.
However, it cannot be used as an AC adapter.
• To avoid interference with reception, do not use
the AC Adapter near a radio.
• Recording time is reduced significantly when
Zoom or Record-Standby mode is engaged
repeatedly or the LCD monitor* is used
repeatedly.
• Before extended use, it is recommended that you
prepare enough battery packs to cover 3 times the
planned shooting time.
* Applicable models only.
Date/Time Settings
1) Set the Power Switch
@
to “ ”.
2) Press the MENU Wheel
1
in. The Menu
Screen appears.
• You can select the language (ENGLISH,
CHINESE or ARABIC) of messages in menu
screens (
੬
pg. 18, 21 “MENU LANG.” in
SYSTEM MENU).
3) Rotate the MENU Wheel
1
to select
“ 4 TO SYSTEM MENU” and press it to display
SYSTEM MENU. Rotate the MENU Wheel
1
to
select “ 4 NEXT” and press it to display the next
page.
4) Rotate the MENU Wheel
1
to select “DATE/
TIME” and press it. The DATE/TIME Menu
appears.
5) To set “YEAR”, “MONTH”, “DAY” or “TIME”
(hour/minute), rotate the MENU Wheel
1
to
select the desired item, and press it. When the
setting begins blinking, rotate the MENU Wheel
1
until the correct setting appears and then
press it. The setting stops blinking.
6) When none of these settings (“YEAR”,
“MONTH”, “DAY”, “TIME”) blinks, rotate the
MENU Wheel
1
to select “EXIT”, and press it.
The Menu Screen reappears with the highlight
bar on “
4 RETURN”.
7) Press the MENU Wheel
1
in to close the Menu
Screen.
• To display the date and time in the camcorder’s
display and on a connected TV, see DATE/TIME
DISP. (
੬
pg. 19) in CAMERA MENU.
• The date/time cannot be stored in memory if the
built-in clock battery runs out. Consult an
authorised JVC dealer for replacement, or set the
date/time as necessary before you start shooting.
24-hour indication