beautypg.com

Using the remote controller in zone 2/3 and, Multiroom control kits, Zone 2 and zone 3 —continued – Integra DTR-8.8 User Manual

Page 131: Using a multiroom kit with zone 2/3, Using a multiroom kit with a cabinet, Using a multiroom kit with other components

background image

131

Zone 2 and Zone 3

—Continued

To control the AV receiver with the remote controller
while you’re in Zone 2 or Zone 3, you’ll need a commer-
cially available multiroom remote control kit for each
zone.
• Multiroom kits are made by Niles and Xantech.

These kits can also be used when there isn’t a clear line
of sight to the AV receiver’s remote sensor, such as when
it’s installed inside a cabinet.

Using a Multiroom Kit with Zone 2/3

In this setup, the IR receiver in Zone 2/3 picks up the
infrared signals from the remote controller and feeds
them through to the AV receiver in the main room via the
connecting block.

The miniplug cable from the connecting block should be
connected to the AV receiver’s IR IN A or B jack, as
shown below. The IR IN A and B jacks are identical. Up
to two IR receivers can be connected.

Using a Multiroom Kit with a Cabinet

In this setup, the IR receiver picks up the infrared signals
from the remote controller and feeds them to the AV
receiver located in the cabinet via the connecting block.

Using a Multiroom Kit with Other

Components

In this setup, an IR emitter is connected to the AV
receiver’s IR OUT jack and placed in front of the other
component’s remote control sensor. Infrared signals
received at the AV receiver’s IR IN A or B jack are fed
through to the other component via the IR emitter. Sig-
nals picked up by the AV receiver’s remote control sen-
sor are not output.

The IR emitter should be connected to the AV receiver’s
IR OUT jack, as shown below.

Using the Remote Controller in
Zone 2/3 and Multiroom Control Kits

IR IN

A or B

Connecting
block

Remote controller

IR Receiver

Main room

Zone 2/3

Signal flow

IR

IN

A

B

OUT

From the connecting block

Miniplug cable

AV receiver

IR IN

A or B

Connecting
block

Remote controller

IR Receiver

Inside
cabinet

Signal flow

IR OUT

IR IN

A or B

Connecting
block

IR Receiver

Remote controller

Signal flow

IR Emitter

Other component

AV receiver

IR

IN

A

B

OUT

Remote control
sensor

Other component

Emitter

IR Emitter

Signal flow

Miniplug

Miniplug cable

AV receiver