Integra DTR-8.8 - Manual (Page 115)

115
Advanced Setup —Continued
• HDMI power control only works with HDMI-compat-
ible components that support it and may not work
properly with some components due to their settings
or compatibility.
• When set to Enable, the AV receiver consumes more
power.
• When set to Enable, the AV receiver enters Ready
mode when set to Standby, and the Ready indicator
lights up instead of the Standby indicator (not North
American model). Also, the AV receiver’s AC outlets
will be on all of the time regardless of whether the AV
receiver is set to On or Standby, or Ready mode in this
case.
TV Control
Select Enable to control the AV receiver from an RIHD-
compatible TV connected via HDMI.
Disable: TV Control disabled.
Enable: TV Control enabled.
Notes:
• Select Disable if your TV is incompatible or you’re
note sure about its compatibility.
• The TV Control setting can be set only when the above
Control and Power Control settings are both set to
Enable.
Network
See “Network Settings” on page 122.
Lock
With this setting, you can protect your settings by lock-
ing the setup menus.
Locked: Setup menus locked.
Unlocked: Setup menus unlocked.
When Locked is selected, only this Lock Setup item can
be accessed.
Lock Setup
Note:
• After changing the Control, Power Control, or TV
Control setting, be sure to turn all of your compo-
nents off and then back on again. Refer to the
instruction manuals for your other components.