Advanced setup —continued – Integra DTR-8.8 User Manual
Page 112
112
Advanced Setup
—Continued
■
Power On Volume
This setting determines what the volume will be each
time the AV receiver is turned on.
When the Volume Display preference is set to Absolute,
the range is Last, Min, 1 to Max. When it’s set to Rela-
tive, the range is Last, –
∞
dB, –81 dB to +18 dB.
To use the same volume level as when the AV receiver
was last turned off, select Last.
Note:
• The Power On Volume setting cannot be set higher
than the Maximum Volume setting.
■
Headphone Level
With this setting, you can offset the headphone volume
relative to the main volume. This is useful if your head-
phones are too loud or too quiet at the volume setting you
usually use when listening through your speakers. The
headphone level can be set from –12 dB to +12 dB.
■
Zone2 Maximum Volume
With this setting, you can limit the maximum volume for
Zone 2.
When the Volume Display setting is set to Absolute, the
Maximum Volume range is Off, 99 to 50. When it’s set
to Relative, the range is Off, +17 dB to –32 dB. To dis-
able this setting, select Off.
■
Zone2 Power On Volume
This setting determines what the volume will be for
Zone 2 each time the AV receiver is turned on.
When the Volume Display preference is set to Absolute,
the range is Last, Min, 1 to Max. When it’s set to Rela-
tive, the range is Last, –
∞
dB, –81 dB to +18 dB.
To use the same volume level as when the AV receiver
was last turned off, select Last.
■
Zone3 Maximum Volume
With this setting, you can limit the maximum volume for
Zone 3.
When the Volume Display setting is set to Absolute, the
Maximum Volume range is Off, 99 to 50. When it’s set
to Relative, the range is Off, +17 dB to –32 dB. To dis-
able this setting, select Off.
■
Zone3 Power On Volume
This setting determines what the volume will be for
Zone 3 each time the AV receiver is turned on.
When the Volume Display preference is set to Absolute,
the range is Last, Min, 1 to Max. When it’s set to Rela-
tive, the range is Last, –
∞
dB, –81 dB to +18 dB.
To use the same volume level as when the AV receiver
was last turned off, select Last.
OSD Setup
■
Immediate Display
This setting determines whether operation details are
displayed onscreen immediately after an AV receiver
function is used.
On:
Displayed (default).
Off:
Not displayed.
Even if On is selected, operation details are not output if
the input source is connected to a COMPONENT
VIDEO IN or HDMI IN.
For optimal video performance, THX recommends that
Immediate Display be turned off.
■
Monitor Type
With this setting, you can specify the aspect ratio of your
TV so that menus are displayed properly.
4:3:
Select if your TV is 4:3 (default).
16:9:
Select if your TV is 16:9.
■
Display Position
This setting determines where on the screen operation
details are displayed.
Bottom:
Bottom of the screen (default).
Top:
Top of the screen.
■
TV Format
See “TV Format Setup (not North American models)” on
page 60.
■
Language
This setting determines the language used for the
onscreen setup menus. You can select: English, German,
French, Spanish, Italian, Dutch, Swedish, or Japanese.
12V Trigger A/B/C Setup