Section 6—seat, Removing/installing the seat assembly, Removing – Invacare Wheelchair Pronto M91 Base User Manual

Page 46

SECTION 6—SEAT

SECTION 6—SEAT

ƽ WARNING

After any adjustments, repair or service and before use, make sure that all attaching

hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that On/Off

switch on the joystick is in the Off position.

Removing/Installing the Seat Assembly

ƽ WARNING

DO NOT store items under seat - interference with seat latch may result.

NOTE: For this procedure, refer to FIGURE 6.1 on page 47.

NOTE: This procedure is for wheelchairs WITHOUT the Formula PTO Plus seating system
ONLY. For wheelchairs with the Formula PTO Plus seating system, refer to Tilting the Seat
Assembly on page 47.

Removing

1. Disconnect the joystick. Refer to Disconnecting/Connecting the Joysticks on page 44.

2. Push down on the latch bar underneath front of seat.

3. Tilt front edge of seat up.

4. Slide the seat assembly forward to disengage seat from the pivot brackets located in

the rear.