Disconnecting/connecting the joysticks, Spj+ joysticks disconnecting connecting – Invacare Wheelchair Pronto M91 Base User Manual

Page 44

SECTION 5—WHEELCHAIR OPERATION

6. If necessary, perform the following to reposition the adjustment lock:

A. Slide the adjustment lock from the mounting bracket.

B. Rotate adjustment lock 180° and slide adjustment lock over the opposite end of the

mounting bracket.

7. Slide joystick mounting tube through the mounting bracket to the desired position

and secure adjustment lock to tube by turning lever on adjustment lock.

FIGURE 5.11 Repositioning the Joystick - Van Seat

Disconnecting/Connecting the Joysticks

NOTE: For this procedure, refer to FIGURE 5.12.

NOTE: The joystick connector is located at the rear of the seat frame.

SPJ+ Joysticks

Disconnecting

1. Hold the light GREY collar portion of the joystick connector with one hand and the

controller connector on the wheelchair in the other and disconnect them by pulling
them apart.

Connecting

ƽ WARNING

The joystick connector and controller connector fit together in one way only. DO

NOT force them together.

1. Hold the light GREY collar portion of

the joystick connector with one hand
and the controller connector on the
wheelchair in the other and align them.

2. Lightly push to engage the joystick

connector and the controller connector.

FIGURE 5.12 Disconnecting/Connecting

Hex Mounting Screws

Locknuts

Adjustment Lock Lever

Joystick Mounting

Tube

Mounting

Bracket

Spacers

Arm Frame

NOTE: MK5 SPJ‐80 joystick
shown, all other joysticks
reposition in the same way.

Joystick

Connector

Light Grey Collar

Controller

Connector