Intel System Board G4H875-N - Manual (Page 86)

8 6
3
BIOS Setup
3.1.5.12 Wake-Up by PCI Card
Enabled This field should be set to Enabled only if your PCI
card such as LAN card or modem card uses the PCI
PME (Power Management Event) signal to remotely
wake up the system. Access to the LAN card or PCI
card will cause the system to wake up. Refer to the
card’s documentation for more information.
Disabled The system will not wake up despite access to the PCI
card.
3.1.5.13 Power On by Ring
Set this field to Enabled to use the modem ring-on function. This will
allow your system to power-on to respond to calls coming from an
external modem.
3.1.5.14 Wake Up On LAN
Set this field to Enabled to allow the network to remotely wake up
a Soft Power Down (Soft-Off) PC. However, if your system is in the
Suspend mode, you can wake up the system only through an IRQ
or DMA interrupt.
3.1.5.15 Wake Up On LAN Connector
If you are using a LAN card that supports the remote wake up
function, set this field to Enabled.
3.1.5.16 USB KB WakeUp From S3(S4)
This field, when enabled, allows you to use a USB keyboard to wake
up a system that is in the S3 (STR - Suspend To RAM) state. This
can be configured only if the “ACPI Suspend Type” field is set to
“S3(STR)”.