Intel System Board G4H875-N User Manual

Page 13

Introduction

Wake-On-LAN

This feature allows the network to remotely wake up a Soft Power
Down (Soft-Off) PC. It is supported via the onboard LAN port, via
a PCI LAN card that uses the PCI PME (Power Management Event)
signal or via a LAN card that uses the Wake-On-LAN connector.
However, if your system is in the Suspend mode, you can power-on
the system only through an IRQ or DMA interrupt.

Important:
The 5VSB power source of your power supply must support

≥

720mA.

Wake-On-PS/2 Keyboard/Mouse

This function allows you to use the PS/2 keyboard or PS/2
mouse to power-on the system.

Important:
The 5VSB power source of your power supply must support

≥

720mA.

Wake-On-USB Keyboard

This function allows you to use a USB keyboard to wake up a
system from the S3 (STR - Suspend To RAM) state.

Important:
• If you are using the Wake-On-USB Keyboard function for 2

USB ports, the 5VSB power source of your power supply
must support

≥

1.5A.

• If you are using the Wake-On-USB Keyboard function for 3

or more USB ports, the 5VSB power source of your power
supply must support

≥

2A.

RTC Timer to Power-on the System

The RTC installed on the system board allows your system to
automatically power-on on the set date and time.