7 installing telescoping i.v. rod, Mounting instructions – Invacare 9000 Topaz User Manual
Page 57
11 OPTIONS
57
Invacare®9000 Topaz™Wheelchair
11.7 Installing Telescoping I.V. Rod
Mounting Instructions
1.
Loosely secure the two bracket plates to the lower mounting bracket using the short spacer, long spacer and two mounting screws and locknuts
(Detail “A”).
2.
Slide the lower mounting bracket over the left side step tube of the wheelchair frame, so that the step tube is positioned between the two spacers.
3.
Remove the existing top left upholstery mounting screw and washer. Discard existing upholstery mounting screw and washer.
4.
Secure the upper mounting bracket and back upholstery to the back cane using the new upholstery mounting screw and washer.
5.
Secure the lower mounting bracket to the wheelchair frame by securely tightening the two (2) hex screws and locknuts on the mounting bracket.
6.
Loosen the adjustment knob and position the IV rod to the desired height and securely tighten the adjustment knob.
For this procedure, refer to FIGURE 6 on page 58.
The telescoping I.V. rod is factory set for installation on the left side of the wheelchair. If necessary to install on the right
side, refer to Repositioning Upper Mounting Bracket on page 59.
Ensure the telescoping I.V. rod is vertical before securing the lower mounting bracket to the step tube.