2 replacing back upholstery, Back cane, Figure 2 replacing back upholstery – Invacare 9000 Topaz User Manual
Page 42: 3 adjusting back height, Hole number, Back height, 7 seat and back
7 SEAT AND BACK
Invacare®9000 Topaz™Wheelchair
42
7.2 Replacing Back Upholstery
1.
Remove the eighteen mounting screws and washers that secure the
existing back upholstery to the back canes.
2.
Install and securely tighten the new back upholstery to the back
canes with the eighteen mounting screws and washers starting with
the top hole of the back cane.
FIGURE 2 Replacing Back Upholstery
7.3
Adjusting Back Height
1.
Remove the four mounting screws and locknuts that secure the two back canes to the wheelchair frame.
2.
Remove the bottom two back upholstery mounting screws from the cane.
3.
Reposition the back canes to one of three height adjustment positions:
Back Cane
Mounting
Screws
Washers
Back Upholstery
For this procedure, refer to FIGURE 3 on page 43.
HOLE NUMBER
1 & 2
2 & 3
3 & 4
BACK HEIGHT
16 inches
17 inches
18 inches
Holes numbered from bottom to top for reference only. (There are no numbers on the back canes).
The mounting screws must be securely tightened into the threaded mounting holes of the wheelchair frame before installing
the locknuts.