8 rear wheels, Warning, 1 removing/installing rear wheels – Invacare 9000 Topaz User Manual
Page 44: Repeat step 2 for the opposite rear wheel, Locknut, Figure 1 removing/installing rear wheels
8 REAR WHEELS
Invacare®9000 Topaz™Wheelchair
44
8 Rear Wheels
8.1
Removing/Installing Rear Wheels
1.
Place the wheelchair frame up on blocks so that the rear wheels are
off the ground.
2.
Remove the dust cap (if applicable), mounting screw and locknut
that secure the rear wheel and axle spacer to the wheelchair.
3.
Repeat STEP 2 for the opposite rear wheel.
4.
To reinstall the rear wheel onto the wheelchair, reverse STEP 2.
FIGURE 1 Removing/Installing Rear Wheels
ƽ
WARNING
After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely. Otherwise
injury or damage may occur.
ƽ
WARNING
Changing the rear wheel size or changing the seat-to-floor height MUST be performed only by a qualified technician.
If replacing the same size rear wheel, note the
mounting position on the wheelchair frame for
proper reinstallation of the new rear wheel.
Make sure axle spacer is between rear wheel and
wheelchair frame.
Locknut
Axle Mounting
Positions
Axle
Spacer
Wheelchair
Frame
Mounting Screw
Rear Wheel