IBM P260 - Manual (Page 12)

Getting Started
4
AC IN
(HD15)
1
(DVI)
2
AC IN
(HD15)
1
(DVI)
2
AC IN
(HD15)
1
(DVI)
2
Setup
This monitor works with platforms running at horizontal
frequencies between 30 and 121 kHz.
Step 1: Make sure the computer and
monitor are switched off
Step 2: Connect the monitor to the
computer
Connect the video signal cable to the video output of the
computer.
Notes
• Do not short the pins of the video signal cable.
• When connecting the video signal cable, check the alignment of
the connector. Do not force the connector in the wrong way or
the pins might bend.
Step 3: Connect the power cord
With the monitor switched off, connect one end of the
proper power cord for your local supply to the monitor and
the other end to a power outlet.
Step 4: Turn on the monitor and computer
To a computer
with an HD15
video output rear side
forward side
To a computer
with a DVI
video output
forward side
rear side
to a power outlet
to AC IN
Power cord
Rear
* Display Data Channel (DDC) Standard of VESA
Pin No.
C1
C2
C3
C4
C5
1
2
3
4
5
6
7
8
9
Pin No.
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
Signal
Red
Green
Blue
H. Sync
Ground (R/G/B)
–
–
–
–
–
Data Clock(SCL)*
Bi-Directional
Data (SDA)*
V. Sync
–
Signal
–
–
–
–
DDC + 5V*
Ground
Hot Plug Detect
–
–
–
–
–
–
–
–
1 2 3 4 5 6 7 8
C1 C2
C5
C3 C4
9 10 12 13 14 15 16 17
17 18 19 20 21 22 23 24
0 Video input 2 connector (DVI) (J2) (page
4)
Connected to a computer with a DVI video output.