Intel I925XE - Manual (Page 31)

Installation
Page 3-15
3-6 T T T T Ther her her her hermo Stic mo Stic mo Stic mo Stic mo Stick Function k Function k Function k Function k Function
This mainboard is equipped with a digital thermometer capability to monitor any
temperature. This is useful for measuring heat on peripherals such as VGA cards,
hard disk drives, DIMMs or even on-board components such as chipset,
MOSFETS, etc.
Thermo Stick consists of:
1) THM_ST header located on the mainboard
2) Thermostick sensor cable with heat-tolerant adhesive
sticker bundled in the mainboard package
3) USDM software utility
To setup Thermo Stick,
1. Insert the sensor cable to THM_ST header on the mainboard
2. Using the adhesive sticker, affix the sensor head of the cable to your desired point
of measure. e.g. the chipset as in the picture below. Trim the adhesive sticker to a
suitable size so that it will not affect the heat dissipation of any heatsink.
3. Ensure the cable is neatly tucked away from fans or other moving parts.
4. Install and run the USDM software. The temperature will be shown as below.
THM-ST